Mobile
Log In Sign Up
Home > english-chinese > "耐冲蚀" in Chinese

Chinese translation for "耐冲蚀"

erosion resistance

Related Translations:
:  Ⅰ动词1.(损失; 亏耗) lose 短语和例子亏蚀 lose (money) in business; 听说他做生意蚀了本。 i hear that he is losing by his business.2.(腐蚀) erode; corrode 短语和例子风雨侵蚀 erosion by wind and rain; 锈能蚀铁。 rust corrodes iron.
冲蚀:  washout; ablation; [地质学] scouring◇冲蚀构造 wash-out structure
耐蚀:  anti-corrosion◇耐蚀材料 corrosion resistant material; 耐蚀钢 [冶金学] corrosion-resisting steel; 耐蚀性 corrosion-resistance; stain resistance
Example Sentences:
1.The wear mechanisms were explored . the results reveal that the erosion resistance of the coatings is obviously superior to a3 steel
研究发现:熔覆层的耐冲蚀性能较a _ 3钢有显著提高。
2.The results are listed as following : the anti - erosion proportion of a3 steel and 1cr18ni9ti stainless steel is not good
发现: a _ 3钢和1cr18ni9ti不锈钢的耐冲蚀性能相似,都不太耐磨。
3.High chromium cast iron has higher erosion resistance at lower impact angle , while the erosion resistance is worse for the lower toughness at normal impact
高铬铸铁在低角冲蚀时有较高的耐冲蚀性,但高角冲蚀时由于脆性大,易崩裂。
4.The erosive wear behaviors of five engineering materials , include a3 steel , 1crl8ni9ti stainless steel , high chromium cast iron , ptfe and corundum , were studied by an air blast tester under ambient
采用气流喷砂型实验装置测试了a _ 3钢、 1cr18ni9ti不锈钢、高铬铸铁、聚四氟乙烯和刚玉五种工程材料的耐冲蚀性能。
5.The mechanism of corrosion and erosion resistance of nicr alloy and cermet coatings were explored and their performance were compared with 20g , 20g covered by dope and the coatings of fecral , nicrti used widely at present
并将由这些新的涂层材料和目前广泛使用的fecral , nicrti以及与未加以保护的20g基体和刷涂料保护的20g在抗高温氧化、高温腐蚀、耐冲蚀磨损和热震性等方面加以比较。
6.Erosive resistance of grey cast iron matrix composite has been investigated , on the condition of different volume fraction of wc and erosive angles and volume fraction of . the results showed that , the erosive resistance of composite with volume fraction of 27 wt % was the best ; volume abrasion rate of composites with different erosive angles was maximum at 50 angle , but volume abrasion rate was less at 0 and 70 angle ; on condition of the same volume fraction of wc and larger size of quartz sand in slurry , volume abrasion rate increased
结果表明:碳化钨体积分数为27的灰铁基复合材料的耐冲蚀磨损性能最佳;不同冲蚀角下复合材料的体积碳化钨颗粒增强铁基表面复合材料及其冲蚀磨损性能研究摘要磨损量在50 “冲蚀角处最大,在0 ”和70 ”冲蚀角处较小;在碳化钨颗粒体积分数相同的情况下,当浆料中的石英砂粒度大时,其体积磨损量增大。
7.When fillings is other materials ( unprocessed montmorillonite , powder coal ash , co - composite of powder coal ash and organo - montmorillonite , co - composite ofcarbonizing calcium and organo - montmorillonite ) in the binder and content of organo - montmorillonite in the binder is five percent decided by tensile - shear experiment , tensile - shear strength of binder is up to tiptop ; at the same time , this paper carries out abrasion experiment , and , by comparison , concludes abrasion property of coating is optimum when content of organo - montmorillonite in the binder coating is five percent , and observes abrasion sample under set
当胶粘剂中填料为其它物质(未处理蒙脱土、粉煤灰、粉煤灰和有机化蒙脱土共复合、碳化钙和有机化蒙脱土共复合)时,通过拉伸剪切试验确定胶粘剂中有机化蒙脱土含量为5时,胶粘剂的拉伸剪切强度最高;同时进行了冲蚀磨损试验,通过比较得出,当胶粘剂涂层中有机化蒙脱土含量达到5时,涂层的耐冲蚀磨损性能最佳,并对冲蚀磨损试样在扫描电子显微镜( set )上进行观察。
Similar Words:
"耐冲击性试验" Chinese translation, "耐冲击性塑料" Chinese translation, "耐冲击值" Chinese translation, "耐冲螺丝成型模具" Chinese translation, "耐冲强度" Chinese translation, "耐冲蚀的" Chinese translation, "耐冲蚀涂层" Chinese translation, "耐冲蚀性" Chinese translation, "耐冲式底板下浇道" Chinese translation, "耐冲试验" Chinese translation