| 1. | Optical fibres - measurement methods - bend loss for a3 and a4 type fibres
光纤.测量方法. a3和a4型光纤的弯曲损耗 |
| 2. | Optical fibres - measurement methods and test procedures - macrobending loss
光学纤维.测量方法和试验规程.微弯曲损耗 |
| 3. | Optical fibres - part 1 - 47 : measurement methods and test procedures - macrobending loss
光学纤维.第1 - 47部分:测量方法和试验程序.微弯曲损耗 |
| 4. | The paper concerns about the theory of the winding less of birefringence optical silico - fiber and elastic - optic effect
本文对单模石英系双折射光纤弯曲损耗弹光效应的理论研究。 |
| 5. | The theory , method and procedure for measurement of the bending loss of single - model quartz fiber by using fiber bragg grating sensor are introduced
摘要阐述了利用布拉格光纤光栅传感器测量单模石英光纤弯曲损耗实验的原理、方法和步骤。 |
| 6. | Accordingly , as far as the bent loss is concerned the ag fiber is highly above the cop / ag fiber , especially when the carve angle is increased
Cop ag空芯光纤的弯曲损耗比ag空芯光纤的弯曲损耗大大降低，尤其是随着弯曲角度的增加，降低的程度更明显。 |
| 7. | Two models were given to analyze the characteristics of distributed spatial filtering of bend multimode fiber and the multimode fiber amplifier in this paper
本论文主要工作是提出了用于分析弯曲多模光纤的空间滤波特性的理论模型和存在弯曲损耗时的光纤放大器等效模型。 |
| 8. | Because it ' s difficult to do the exact and delicate analysis in theory . the research paper shows us a new method that can test the winding waste of quartz system ' s birefringence optical fiber
由于理论上难以进行细致而精确的分析，本文给出了测试单模石英系双折射光纤的弯曲损耗及弹光效应的一种新方法。 |
| 9. | The relationship between bending loss and the structural parameters of soi rib waveguide was analyzed by the method presented , and the offset at the junction of bent and straight rib waveguides was optimized as well
采用该方法，研究了soi脊型波导的弯曲损耗与波导结构参数之间的关系，并对直弯波导的连接进行了优化。 |
| 10. | The paper presents the experiment equipment for the measurement of the elastic - optic effect of curled birefringence fiber , then analyzes spectrogram at winding loss , and the rule of the circle of optical fiber producing elastic - optic effect
摘要给出测试单模双折射光纤弯曲时弹光效应的实验装置，分析了弯曲损耗光谱，定性提出光纤圈产生弹光效应的规律。 |
