| 1. | These formulae give us the stress and strain in a prismatic beam when it is subjected to pure bending .
当棱柱形梁受纯弯曲时，这些公式给出了它的主力和主变。 |
| 2. | In a beam type compensator a stress pattern produced by pure bending is frozen into the material .
在梁式补偿器中，其应力光图是由纯弯曲产生而被冻结在材料之中。 |
| 3. | According to the original assumption, this theory should be applied only to long, thin beams loaded in pure bending .
根据原来的假定，这个理论只适用于受纯弯曲载荷的长而薄的梁。 |
| 4. | Specifications for the rotary bending fatigue testing machines
纯弯曲疲劳试验机技术条件 |
| 5. | Calculation of re - spring bending moment for beams of circular section
圆形截面杆纯弯曲回弹弯矩的计算 |
| 6. | Verification regulation of rotating pure bending fatigue testing machines
旋转纯弯曲疲劳试验机检定规程 |
| 7. | Optimization algorithm for large deformation of a cantilever beam with elastic - perfectly plastic model under pure bending
纯弯曲理想弹塑性模型梁大变形的优化算法 |
| 8. | Meanwhile , the springback potential energy principle is applied to calculate the springback deformation of a pure bending of curved beam
同时，应用该回弹势能原理于纯弯曲梁的回弹变形计算。 |
| 9. | Its reliability has been tested though examining . the influence laws of mould structure , including wiper die and the style , size and installed position of mandrel , have been studied . combined with the theoretical analysis of perfect pure bending , the tendency of relative bending radius r / d and relative wall thickness t / d to one of the major quality target - the maximum wall thickness reduction ratio is also studied
通过数值模拟研究获得了包括防皱块和芯棒形式、尺寸和安装位置在内的模具结构对制件成形质量的影响规律；结合对理想纯弯曲的理论分析，研究获得了相对弯曲半径r / d 、相对壁厚t / d对制件主要质量指标之一的最大壁厚减薄率的影响趋势和大小。 |
| 10. | The calculation method of the utmost load of gray cast iron beam with rectangle section is obtained through the analysis of limit load behavior of the beam under the united action of bending and pulling , therefore the design method of limit load about forcing parts of cast iron pressure vessels is determined
通过分析灰口铸铁矩形截面梁在纯弯曲和拉弯组合作用下极限载荷行为，提出灰口铸铁矩形截面梁极限载荷的计算方法，由此确定灰口铸铁压力容器受压元件的极限设计方法。 |
