| 1. | In cumulus convection ascent rates of several metres a second give a cooling rate of a few degrees per minute .
在积云中，每秒几米的对流上升速度造成的冷却速率为每分钟几度。 |
| 2. | When the cooling rate is lower or higher than 10 / s , the segregation is diminished
当冷却速率为10 s时， sn的品界偏聚量最大，热塑性最低。 |
| 3. | Influence of overheated temperature and cooling rates on the level of undercooling was analyzed respectively
分析了过热度、冷却速率分别对过冷度的影响。 |
| 4. | There is non - equilibrium grain boundary segregation of sn during continuous cooling and the quantity is different with different cooling rate
当冷却速率低于或高于10 s时， sn的晶界偏聚量减少，热塑性升高。 |
| 5. | The experiment shows that the cooling rates increased dramatically as the ejecting speeding and the sub - liquid nitrogen sub - coolings increased
实验研究表明随着小样品沉浸速度的增大、液氮过冷度的增加，冷却速率明显增加。 |
| 6. | A high speed quench cooling manipulator can be added to the stage so that cooling rates of > 5000 c / min can be achieved ( faster than immersing in ln2 )
此台体具有高速淬火冷却功能，冷却速率大于5000 c /分（比浸入液旦还快） 。 |
| 7. | A useful method to distinguish the categories of titanium oxides is found according to their diameter and cooling rates
此外，可以根据冷却速率和凝固后氧化钛的尺寸判断氧化钛是凝固前形成的一次氧化物还是凝固过程中产生的二次氧化物。 |
| 8. | As the equipment was used to study the ultra - rapid cooling of a small sample in sub - liquid nitrogen , the high quenching speeds and the high cooling rates could be reached
将其应用于小样品在过冷液氮中的超快速冷却过程，可以实现较高的沉浸速度和冷却速率。 |
| 9. | Lts120 - this system is based on the highly successful lts350 stage design and comes with linksys temperature control software to enable varying rates of heating and cooling within a sealable environment
这种系统采用了非常成功的lts350热台设计，由软件控制温度，达到在密闭环境中改变加热和冷却速率。 |
| 10. | Pdlla / ha composite fibers were produced by melt spinning , and the choices of the process parameters such as temperature , revolving speed and drawing speed etc were discussed
选用熔融纺丝法制备pdlla ha复合纤维，探索了熔融纺丝过程中温度、挤出机转速、拉伸速率、加料速度和冷却速率等一系列工艺参数的选择及其影响因素。 |
