| 1. | Method for aperture - forming effect of colloidal graphite for kinescope
显象管石墨乳试验方法造孔性试验方法 |
| 2. | Porous bioglass material was prepared by attempting to add pore former
摘要尝试采用添加造孔剂的方法制备了多孔生物玻璃材料。 |
| 3. | Code for construction and rockmass testing borehole for hydroelectric and water resource geotechnical projects
水电水利岩土工程施工及岩体测试造孔规程 |
| 4. | As showed by the results , mpf is advantageous for the stable formation or growth of pre - sintered glass beads , and it can partly guarantee the desired " results of sintering
研究结果表明，利用复配造孔剂有利于颗粒的稳定生成和成长，在一定程度上保证烧结过程达到理想状态。 |
| 5. | The results show that factors affecting the pore diameter of porous materials are the sintering temperature and time , the added quantity of pore former and the granularity of glass powder etc
研究结果表明：烧结温度和时间、造孔剂的用量及玻璃粉体的粒度等都将影响多孔材料的孔径。 |
| 6. | Improvement of power output has also been achieved by increasing the porosity of the anode catalyst layer , so that the co2 produced there can be easily released
本研究还以促进co2气体排放为目标，采用添加造孔剂的方法提高了液体进料dmfc阳极催化剂层的孔隙率，显著地改善了电池性能。 |
| 7. | Conventional construction techniques have been employed in all procedures such as drilling , fabrication , installation , grouting and stressing . all anchor tendons are removed from the borehole in the end
按照常规的锚索施工工艺进行造孔、制作、安装、注浆与张拉等各道工序的施工，并在最后对锚索体进行了回收。 |
| 8. | Abstract : in this paper , the porous - metal nickel was prepared by filling pore - forming material and vacuum sintering process . the influence of pore - forming material on the properties of porous - metal nickel was discussed
文摘:采用添加造孔剂、真空烧结工艺制备了多孔金属镍材料，并主要讨论了造孔剂含量对材料性能的影响。 |
| 9. | This paper has done thorough investigation and discussion on how to improve the amounts of organic foam body ' s thick fluid and the effect which has made on the performance of carrier by the porous handicraft , has provided a very important reference to optimize the carrier of mesh porous ceramics
并对如何改善有机泡沫体的挂浆量和造孔工艺之于载体性能的影响作了深入探讨，为优化网眼多孔陶瓷载体提供重要参考。 |
| 10. | Air electrode , in which nh _ 4hco _ 3 is as pore former , is mainly studied in this paper . the manufacturing process of air electrode , the composition of waterproof and gas diffusion layer , the composition of catalysis layer , and two kinds of catalyst were studied by numbers
本文针对以碳酸氢铵为造孔剂的空气电极进行研究,分别对电极制作工艺、防水透气层组成、催化层组成以及两类催化剂进行了初步系统的探索和研究。 |
