Mobile
Log In Sign Up
Home > chinese-english > "弯曲模" in English

English translation for "弯曲模"

bending dies

Related Translations:
导向弯曲:  guided bend
晶格弯曲:  lattice bending
快速弯曲:  quick warp
强迫弯曲:  forced bending
抗弯曲:  counter bending
纯弯曲:  direct flexurepure bendingpure flexuresimple bending
主弯曲:  principal curvature
弯曲发夹:  bobby pin
弯曲弧:  bend arc
平直弯曲:  flat bendflat wise bendflatwise bend
Example Sentences:
1.Designing of low - cost u - type bending die
弯曲模设计
2.The construction design of the bending die for improving the surface finish of parts
提高工件表面质量的弯曲模结构设计
3.Influence of combined modes of piezoelectric ceramics on flexural vibration of a beam
压电陶瓷的组合结构对直梁弯曲模态的影响
4.Flexural modulus gpa
弯曲模量gpa
5.Bottoming bending die
校正弯曲模
6.Paper and board - testing of cores - determination of flexural modulus by the three - point method
纸和纸板.芯层试验.采用三点法对弯曲模量的测定
7.Paper and board - testing of cores - determination of natural frequency and flexural modulus by experimental modal analysis
纸和纸板.芯层试验.通过试验模型分析法对自然频率和弯曲模量的测定
8.The working modes were the ninth bending in - plane vibration modes , which had almost the same frequencies and realized movement of forward and backward using the same power supply
利用振子第9阶同频的两个正交的面内弯曲模态分别实现直线电机的正、反方向驱动。
9.Prediction values of two braided composites agree well with their experimental values . influence of fiber volume content and braiding angle on specimens " strength was analyzed
从而论证了对于三维编织复合材料,测试弯曲模量和强度使用四点弯曲试验更合适。
10.The problem that ommt resulted in pvc degraded was settled . but na - mmt in pvc / na - mmt composite was simply common filler , the space of the layers was 1 . 29nm
通过力学性能测试发现,在蒙脱土含量为7phr时,硬质pvc的缺口冲击强度最大提高了108 % ,弯曲模量也有所提高。
Similar Words:
"弯曲轮廓" English translation, "弯曲脉冲试验" English translation, "弯曲毛细管" English translation, "弯曲面" English translation, "弯曲明显" English translation, "弯曲模板" English translation, "弯曲模具" English translation, "弯曲模量" English translation, "弯曲模数" English translation, "弯曲模膛" English translation