| 1. | A method to control the corrosion of high temperature section is provided
提出了一种方法来控制和评估高温区的腐蚀。 |
| 2. | Life may have evolved on earth and other planets in geothermally heated environments
生命可能源于地球或其他行星上受地热影响的高温区 |
| 3. | Using radon measure technique to explore no . 1303 comprehensive caving face combustion high - tempreture area
应用测氡技术探测综放面煤自燃高温区 |
| 4. | 2 in summer , haidian and fengtai lie in an area with high temperature . these areas are the main are as of the urban heat island over beijing area
2夏季，城市西部海淀到丰台一带处在一个高温区，构成北京“热岛”的一个主要区域。 |
| 5. | At the area of high temperature at the bottom of dryer , thermal sensitive material does not contact with hot surface . it solves coking and discoloring problem of thermal sensitive material
在干燥机底部高温区，热敏性物料不与热表面直接接触，解决了热敏性物料的焦化变色问题。 |
| 6. | Pm increases whereas pm decreases with the rise of temperature , which narrows the allowed pressure range for the safe and stable levitation of the processed drops at higher temperatures
Pm和pm随温度的升高分别增大和减小，从而缩小了在高温区稳定安全地悬浮液态样品的声压范围。 |
| 7. | For large blast furnaces , the change of main operation parameters are analyzed and gas channels in high temperature and lower part of blast furnace an discussed for three modes
在大型高炉工况条件下，解析了3种富氧操作方式下主要冶炼参数的变化规律，以及高炉下部高温区煤气通道状况。 |
| 8. | We investigated the transformation of the combustion with the increase of centrifugal force . when the acceleration became bigger , the temperature of high temperature field is increased and the flame became wider
研究了燃烧随着加速度增加的变化情况，随着加速度的增大，高温区的温度升高，火焰变宽。 |
| 9. | At the bottom of drier , where is high temperature area , heatsensitivity raw material can not contact with heat surface directly , therefore it solves the carbonization and color charge problems of heat sensitivity raw material
在干燥机底部高温区，热敏性物料不与热表面直接接触，并装有特殊装置，解决了热敏性物料的焦化变色问题。 |
| 10. | Research points out that the three key factors , which determine the nox emissions , are maximum peak temperature , rich oxygen concentration and the duration in which combustion products stay at high temperature zone
船舶柴油机的氮氧化物主要是山于大气中的氮在柴油机燃烧过程中被氧化而成。研究表明高温、富氧以及燃烧产物在高温区的停留时间是决定氮氧化物排放量的三个决定因素。 |
