Mobile
Log In Sign Up
Home > english-chinese > "通信总线" in Chinese

Chinese translation for "通信总线"

cb communication bus
communication bus


Related Translations:
总线输入总线:  bus-in bus
指令总线:  instruction bus
加法总线:  add busbus, summingsumming bus
供水总线:  service main
视频总线:  video bus
浮动总线:  floating bus
总线接插件:  bus connector
总线驱动器:  bd bus driverbus driver
扩充总线:  expa ion bus
系统总线:  mainbussystem bus
Example Sentences:
1.Cc - link control communication link specifications
控制与通信总线cc - link规范
2.Advanced aircraft power system and its control system was introduced and fault tolerant design of data bus was discussed
摘要介绍了先进飞机供电系统及其控制系统的组成,并对数据通信总线的容错设计进行论述。
3.Besides the basal acknowledge , the dissertation describes design and implementation of the 1553b bus communication network experimental platform system in detail
作为系统研制的硬件基础知识,本文简介了1553b航空通信总线的有关技术,包括系统结构、节点类型、运行模式等。
4.I2c bus is the serial bus that is applied widely and is dissertated in the paper . because the work frequency of the system is more high , anti - jamming measures is very important in pcb design
At24co1作为数据的外部存储芯片。 i ~ 2c总线作为得到广泛应用的串行通信总线,论文对其作了详尽的论述。
5.In addition , the analog quantity and switch quantity control of the former system is replaced by the digital quantity control , which can improve precision of production and reliability of the system
另外,系统采用基于sci串行通信总线的数字控制,代替原系统中的模拟量和开关量控制,能够有效提高系统的生产精度,改善系统的可靠性。
6.On the basis of this , accomplish the design of the structure of the control system and complete the function assign to the intelligent nodes , chose the right net type and bus type , so as to complete the plan design
在此基础上提出挖掘机器人分布式控制系统的结构,完成各智能节点功能分配和选择合适的网络拓扑结构和通信总线,实现分布式控制系统的方案设计。
7.Ethernet , controlnet and can , the three control bus , which are in common use , are analyzed . by comparing their characteristics of function of the mac sub - layer and considering the requirements of control systems on - board , can bus has been chosen in the communication system built in locomotive
分析了ethernet , controlnet , can三种典型的控制总线,通过比较分析其mac子层的性能特点,结合车载控制系统要求,采用can总线作为系统的通信总线
8.Equivalent cure control is employed for this system , men , according to the conclusion of discussing , determine to select ethernet structure for the upper level hi this system and select genius bus as fieldbus for communication hi the lower level , hi addition , introduce network operation system , program design language and network management software etc .
然后结合前二章的内容,决定采用以太网作为本系统上层的控制网络, genius现场总线作为现场的通信总线。此外还介绍网络所采用的操作系统软件、应用软件与网络管理软件等。
9.The first part is the general interface of the hardware , which drives , monitors the ultrasonic sensor , receives signals generated by the sensor , converts the analog signals into numerical formats and sends them to the computer through a communication line . the second part is concerned with designing and implementing the software to be used by the vi
第一部分是以单片机为核心的超声波发射接收卡的设计,其作用是驱动超声波探头工作,接收材料中的缺陷超声回波信号,将其转换为计算机可以处理的数字信号,并通过通信总线发送给计算机。
10.Devices installed on high voltage equipments work under the control of single - chip computer of intel 80c196kb . rs485 is chosen as physical standard of the communication system . it has excellent performance of anti - interference and a very low cost . to ensure the host computer can reliably communicate with all devices , we formulated a flexible communication protocol
本系统现场智能装置采用inte180c196单片机系统,通信总线采用了抗干扰能力很强,并且非常经济的rs485总线,我们编写了一套完善的通信协议,能很好的满足系统工作的需要。
Similar Words:
"通信字处理设备" Chinese translation, "通信字处理系统" Chinese translation, "通信综合布线工程师" Chinese translation, "通信综合研究所" Chinese translation, "通信总数" Chinese translation, "通信阻断" Chinese translation, "通信作业程序" Chinese translation, "通信作业教令" Chinese translation, "通信作业排" Chinese translation, "通信作业区指示器" Chinese translation