| 1. | We have found a solution which does not cross the axis and one which crossed the axis once .
我们已经求得了一个不通过轴线的解以及一个只通过轴线一次的解。 |
| 2. | Thus the path of the vehicle mass center must be a circle around the axis, i. e. it must be a minor circle of the earth, lying on a parallel of latitude .
所以飞行器质心的轨迹必须是围绕轴线的一个圆，即它必须是一个平行于纬度线的地球的小圆。 |
| 3. | it is usually convenient to replace δs by its components δs1 and δs2 parallel to any two perpendicular axes ox, oy in the plane.
通常用它的分量s1和s2来代替s较为方便，它们分别沿平面内的ox，oy两个正交的轴线的方向。 |
| 4. | Characteristic impedance of a rectangle coaxial line with round center conductor
边界元法计算内圆外矩同轴线的特性阻抗 |
| 5. | Then the eigenequations were obtained by using the recursive relations among their coefficients
利用电磁场的系数递推关系，进一步推出了此种同轴线的特征方程。 |
| 6. | There is a several handreds meters corridor from yong an shop to kuiguang attic on banks of qinhuai river
?轴线的河厅河房景观。河北岸建成了东起永安商场西至 |
| 7. | Test conditions of machining centres . part 4 : accuracy and repeatability of positioning of linear and rotary axes
加工中心.检验条件.第4部分:线性和回转轴线的定位精度和重复定位精度检验 |
| 8. | Test code for machine tools - part 2 : determination of accuracy and repeatability of positioning numerically controlled axes
机床检验通则第2部分:数控轴线的定位精度和重复定位精度的确定 |
| 9. | Machine tools - test conditions for machining centres - part 4 : accuracy and repeatability of positioning of linear and rotary axes iso 10791 - 4 : 1998
机床.加工中心的检验条件.第4部分:线性和回转轴线的 |
| 10. | They also built a brick wall about 2 meters with 2 doors in the front and rear section for workers to pass in and out
主体上方尚有增建高约2公尺左右的砖壁，四周封闭仅于垂直中轴线的二端各开设一处门洞，以作为进出工作走道的门户。 |
