| 1. | Temperature difference and setting temperature
温差”和“设定温度 |
| 2. | When displaying current temperature , the temperature is between setting temperature
在显示温度状态，温度介于“设定温度 |
| 3. | Min setting temperature
最低设定温度 |
| 4. | Max setting temperature
最高设定温度 |
| 5. | Temperature difference , and it stops heating when the temperature is over setting temperature
温差”时启动制热，一直到温度高于“设定温度 |
| 6. | Here the nixietube shows the temperature of setting , then use the key
指示灯亮，进入温度设置状态，这时数码显示器上显示的温度即为设定温度，然后用 |
| 7. | Temperature difference , and it stops refrigerating when the temperature is under setting temperature
温差”时启动制冷，一直到温度低于“设定温度 |
| 8. | When temperature controller is properly installed , set the point at the maintenance temperature of media
防爆温控器正确安装后，应将其设定温度调整在介质维持温度上。 |
| 9. | Controlling temperature can set according to temperature set and temperature difference . if set temp is 20
温度控制根据“设定温度”和“温差”两个参数进行，假设“设定温度”为 |
| 10. | The program may prevent the mixer from resuming activity until the temperature has dropped back to the established point
程序直到温度返回到允许的设定温度后，才能恢复搅拌过程。 |
