| 1. | Body surface pressure distribution test
车身表面压力分布试验 |
| 2. | The dynamic surface pressure was obtained according to experimental data
根据所测非平衡张力，对应动态表面压力数据也进行了计算。 |
| 3. | Effects of leeside vortex isolation on pressure distribution over a high - alpha body of revolution
背风涡隔离对大攻角旋成体表面压力分布的影响 |
| 4. | Then the reliability of the dynamic force musurement method is validated through integral of wind pressure data on the surfaces
然后通过表面压力积分验证动态测力的可靠性。 |
| 5. | The kutta condition of equal pressure on upper and lower at the trailing edge of the propller and the duct is executed
通过迭代使桨叶随边和导管尾缘处上下表面压力相等，满足了库塔条件。 |
| 6. | The result shows that the pressure distribution on the cylinder and the wake are modified , and the separate flow partially is attached to the surface again
相邻微作动器存在相位差时，圆柱上下表面压力系数的差值发生改变，进而使绕流圆柱的气动性能发生变化。 |
| 7. | The typical velocity field and the pressure on the step surface of the stepped spillway are measured using the laser doppler anemometer and the piezometer tube respectively
采用多普勒激光测速仪和测压管分别对阶梯溢流坝面典型速度场和阶梯表面压力进行详细测量。 |
| 8. | Prediction of hydrodynamic pressure . the thesis presents a practical engineering method to predict the hydrodynamic pressure on instantaneous wet ship surface
关于水动压力预报：本文提出了基于二维扰动流场频域稳态解的一种预报船体瞬时湿表面压力分布的工程实用方法。 |
| 9. | The sources are distributed on the bodies and cavity surfaces , a computer program is written to display curves of the pressure coefficient value and velocity value of the supercavity surface
通过在回转体表面和空泡表面分布源汇的方法，建立了求解回转体超空泡表面压力系数和速度的计算公式。 |
| 10. | The unsteady surface pressures on the rotor blades of a single - stage low - speed axial compressor were measured by means of mounting micro - sensors on the surface the blades
摘要为了研究上游叶片尾迹对轴流压气机转子叶片非定常表面压力的影响，采用在叶片表面埋设微型压力传感器的方法，测量了一个单级低速轴流压气机转子叶片的非定常压力分布。 |
