Chinese translation for "脉动率"
|
- percentage ripple
pulsation coefficient
pulsation rate
ripple percentage
Related Translations:
热脉动: pulse of heatthermal pulse 脉动现象: pulsation phenomenon 电脉动: electric impulseelectric pulse 剪应力脉动: shear-stress fluctuations
- Example Sentences:
| 1. | Thrust fluctuation ratio
推力脉动率 | | 2. | If the coefficient of engagement overlap decreases , the flow aggrandize , trapping volume and the flow pulsating ratio decreases
随着齿轮啮合重合系数的减小，齿轮泵的流量增大，困油容积和流量脉动率减小。 | | 3. | In addition , a calculating method of parametrically designing hydraulic motor with non - circular planetary gear is proposed aiming at maximal unit displacement and the minimal pulsation ratio by means of visual c + + 6 . 0 software
此外,探讨了以单位体积排量最大为设计目标,流量脉动率最小为约束条件对非圆行星齿轮液压马达的参数化设计方法。 | | 4. | Secondly , based on the research of flow characteristic of hydraulic motor with multi cylindrical gear , optimal conditions of tooth number are got to minimal the pulsation ratio of motor in the design of hydraulic motor
其次,通过对圆柱多齿轮式液压马达的流量特性进行研究分析,得出使其排量脉动率最小所必须的各齿轮齿数应满足的设计准则。 | | 5. | Then a formula about flow of the gear pump and the coefficient of engagement overlap to find is obtained by area method . through analysis contact ratio and overlap ratio has the effect on the volume oil and the flow pulsating ratio
然后采用面积法求得齿轮泵流量与齿轮啮合重合系数的关系式，研究了齿轮啮合重合系数对齿轮泵困油和流量脉动率的影响。 | | 6. | The tooth shape of gear pump has important influence on machining and characteristics of pumps , such as flow rate , fluctuation rate and noise etc . first , the working principle of tatsuno combined pumps is analyzed in this article
齿轮泵的齿形对泵的加工、性能（如：流量、脉动率、噪声）等有很大的影响。本文首先分析了进口tatsuno组合泵的工作原理，并进一步分析了其采用一对双圆弧齿轮的优缺点。 | | 7. | Although the flux per revolution of the optimized pumps is a little smaller than that of tatsuno combined pumps , other characteristics , such as fluctuation rate , maximum pressure angle and velocity fluctuation rate etc , are much better . the methods to cut gears are proposed in the theory for the practical produce in the future
虽然，在体积相等的条件下，优化出来的外圆弧包络线内啮合齿轮泵的排量略小于tatsuno组合泵的排量，但其它性能（如：流量脉动率、最大压力角、速度波动量）都更优。 | | 8. | The researchful results indicate that the flux pulse ration of ordinary helical gear pump without clearance is less than that of the gear pump with clearence under the condition that the main parameters are same , and the flux pulse ration of ordinary helical gear pump is less than that of whole profile meshing helical gear pump
研究结果表明：在主要参数相同的情况下，普通斜齿齿轮泵无侧隙时流量脉动率小于有侧隙时的流量脉动率；全齿廓啮合斜齿轮泵比普通斜齿轮泵的流量脉动略小。 | | 9. | Then , under the condition of satisfied the output volume request , a designing method of parametrically designing hydraulic motor with multi cylindrical gear is proposed aiming at minimal cubage with by means of visual c + + 6 . 0 software , a calculating method of parametrically designing hydraulic motor with non - circular planetary gear is proposed aiming at maximal unit displacement and the minimal pulsation ratio by means of visual c + + 6 . 0 software , and some designing method examples are provided for verifying the accuracy and possibility of those design methods
再次,在满足排量要求条件下,以体积小为设计目标,利用visualc + + 6 . 0软件对圆柱多齿轮式液压马达进行了参数化设计软件的开发;另外,以单位体积排量最大为设计目标,以流量脉动率最小为约束条件,利用visualc + + 6 . 0软件对具有圆柱行星齿轮的非圆行星齿轮液压马达的参数化设计软件进行了开发。 |
- Similar Words：
- "脉动流动" Chinese translation, "脉动流化床" Chinese translation, "脉动流量测量" Chinese translation, "脉动流速" Chinese translation, "脉动虑波器" Chinese translation, "脉动滤波器" Chinese translation, "脉动面" Chinese translation, "脉动能" Chinese translation, "脉动喷井" Chinese translation, "脉动喷气发动机" Chinese translation
|
|
|
