| 1. | Steady state response of the coupled lateral - torsional vibrations of geared rotor system under a holonomic constraint
完整约束下齿轮啮合转子系统的弯扭耦合振动稳态响应 |
| 2. | Bode plots of the system transfer function are used to determine the effects of various inputs ( including a step ) upon the steady - stat response of the system
系统传递函数的伯德图可以用于确定各种输入（包括阶跃输入）下系统的稳态响应。 |
| 3. | Since the frequency response is a steady - state response , the system must be stable and its stability must be determined before the system bode plots can be used
因为频率响应为稳态响应，所以系统必须是稳定且其稳定性必须在绘制伯德图之前确定。 |
| 4. | In this system , the soft hardware complex - compensate technique is adopted to enhance the precision of temperature control , the analog pi controller , whose parameters are adjusted by analog fuzzy controller , is designed to enhance the stationary response
该温度控制系统利用软硬件复合补偿的方法提高温度控制的精度,利用模糊参数可调的模拟pi控制器提高系统的稳态响应。 |
| 5. | The steady - state response of a counter - rotating dual - rotor structure with one inter - shaft bearing was analyzed , of which the low pressure rotor is coupled with the inter - shaft bearing ' s outer ring , and the high pressure rotor coupled with the inter - shaft bearing ' s inner ring
分析了一种具有中介轴承的反向旋转双转子结构的稳态响应，其中介轴承外圈与低压转子联接，内圈与高压转子联接。 |
| 6. | Using this method , the simulation can be performed with large step ( low order wavelet ) for transient state response , and small step ( high order wavelet ) for steady state response so that the excessive computing time for transient state simulation can be saved
该方法可以对电路瞬态响应过程用大步长（低阶小波）模拟，而对稳态响应过程用小步长（高阶小波）模拟，从而避免了为得到电路稳态响应而在瞬态响应时期花费大量的模拟时间。 |
| 7. | The sensor is calibrated , then the relative curve of heat flux vs thermal voltage is determined . moreover , the test of responses of steady state and transient state has been done and the results are compared with predecessors ? results , and proved to be advanced in response speed
在此基础上对薄膜热流计进行了稳态响应测试和瞬态响应测试，并与国外的结果进行了比较，结果表明，该热流计在响应速度方面较快，在灵敏度方面稍低。 |
| 8. | In this paper , the study method is adopted for employing matlab to simulate the transition feature of track circuit , the steady - state response of track circuit is simulated when the alternative sine wave signal is inputted , and the corresponding results are interpreted
城市轨道交通的迅速发展要求对轨道电路的特性有深入的了解。本文采用matlab软件模拟轨道电路的传输特性，对轨道电路在正弦交流输入下的稳态响应进行了仿真，得到了相应的的仿真结果和曲线图。 |
| 9. | The frequence and modal of main stream piping were analysed under the condition of different velocity of stream and the valve taken as the centralizing mass . this paper also gives the responses of steady state under the condition that the frequency of forced vibration is 4hz 、 8hz 、 12hz respectively
将阀门作为集中质量处理，分析计算不同蒸汽流速下，某汽轮机主蒸汽管道系统的振动频率和振型，并给出了激振力频率分别为4hz 、 8hz 、 12hz时该管道系统的稳态响应。 |
| 10. | 3 . according to the principle of the finite element method , the research establishes finite element models of the vibration transportation mechanisms , some model parameters such as the frequency and vibration type are confirmed and validated by the modal analysis , then which analyzes dynamic - state response of the model and confirms the swing distributing of the models , thereby make the design of models precise . 4
根据有限元法的理论，建立振动机构的有限元力学模型，对该力学模型进行模态分析，通过模态分析确定抛秧机振动形态和所需的频率等参数；然后此基础上再进行力学模型的稳态响应分析，研究该模态下机构的振幅分布，以确定模型设计的准确性。 |
