Chinese translation for "砂轮转速"

grinding wheel speed
speed of grinding wheel

Related Translations:

砂轮:  [机械工程] emery cutter; knife grinder; grindstone; buzzer; abrasion wheel; carborundum wheel; emery wheel; sandstone disk; stone wheel; grinding wheel◇砂轮电机 grinding wheel drive motor; 砂轮机 gri

砂轮周长:  schleifscheibenumfangslnge peripheral length of grinding wheel

薄片砂轮:  sheet wheel

平行砂轮:  parallel grinding wheel

砂轮轴:  grinding indlegrinding spindlegrinding wheel spindle

泥砂轮:  sand wheel

金刚砂砂轮:  emery grinding wheel

砂轮盘:  abrasive disc

砂轮切割:  abrasive cutoffabrasive cutting

砂轮式:  stone roughing

Example Sentences:

	1.	The results show that , when increasing the feed rate of the grinding wheel , decreasing the rotating speed of the wafer chuck table and using coarser grit grinding wheel , the material removal rate in the wafer rotating grinding increase , the feed rate of the grinding wheel has greater influence on the material removal rate ; when suitably increasing the rotating speed of the grinding wheel , decreasing the feed rate of the grinding wheel and using finer grit grinding wheel , the wafer surface roughness can be reduced ; there exists a critical rotating speed of the grinding wheel ( about 2300rpm ) , beyond which the material removal rate evidently decreases and the spindle motor current and wafer surface roughness steeply increase ; when the grit size of the grinding wheel is finer than # 2000 , the material removal rate decreases and the wafer surface roughness has no obvious improvement 研究结果表明，增大砂轮轴向进给速度和减小工件转速，采用粗粒度砂轮有利于提高磨削矽片的材料去除率，砂轮轴向进给速度对材料去除率的影响最为显著；适当增大砂轮转速，减小砂轮轴向进给速度，采用细粒度砂轮可以减小磨削表面粗糙度；在其它条件一定的情况下，砂轮速度超过一定值会导致材料去除率减小，主轴电机电流急剧增大，表面粗糙度变差；采用比# 2000粒度更细的砂轮磨削时，材料去除率减小，矽片表面粗糙度没有明显改善。
	2.	By using a wafer - rotating grinding machine , the influence of the main process factors including grit size of diamond grinding wheel , rotating speed of the wafer chuck table , rotating speed and the down feed rate of the cup grinding wheel on the material removal rate , spindle motor current and wafer surface roughness in grinding large size wafer are experimentally investigated 摘要利用基于自旋转磨削原理的矽片超精密磨床，通过试验研究了砂轮粒度、砂轮转速、工件转速及砂轮进给速度等主要因素对材料去除率、砂轮主轴电机电流以及磨削后矽片表面粗糙度的影响关系。

Similar Words：

"砂轮轴向无移的磨削" Chinese translation, "砂轮主轴" Chinese translation, "砂轮主轴横向进给" Chinese translation, "砂轮主轴偏心行程" Chinese translation, "砂轮主轴伸出" Chinese translation, "砂轮装置" Chinese translation, "砂轮座" Chinese translation, "砂脉石" Chinese translation, "砂锚" Chinese translation, "砂煤" Chinese translation