| 1. | The process by which the transformer is enabled to draw the requisite amount of power is as follows .
使变压器能够从电源输入必要数量的功率的过程如下。 |
| 2. | Study of the input over - voltage protection circuit based on uc
3842的开关电源输入过压保护电路研究 |
| 3. | Plug the power wires of protectors into the power input socket
将保护器的电源线插在电源输入插座上。 |
| 4. | The indicator should keep red while rating utility power is available
9指示灯在有额定电源输入时需保持恒红 |
| 5. | Be sure to connect the power input cord after all other cords have been connected
务必在所有其它电线已连接后再连接电源输入线。 |
| 6. | Press and hold the reset button accessible through the small hole on the back just above the power input
按住复位按钮位于后面电源输入上方的小孔。 |
| 7. | Connect the yellow and red power input leads only after all other leads have been connected
只有连接其它所有导线后，才能连接黄色和红色电源输入导线。 |
| 8. | The low - melting - point sn - pb - bi alloy was used as simulacrum to investigate the distortion of meniscus
结果表明：当电源输入频率增大时，结晶器内的磁感应强度减小。 |
| 9. | First connect the black ground lead , then connect the orange / white striped , yellow and red power input leads
首先连接黑色地线，然后连接橙色白色条纹线、黄色和红色电源输入线。 |
| 10. | Viewed from the power line side the lisn is a low pass filter that isolates disturbance from the power line by up to 40db
从电源输入一边看， lisn是一个低通滤波器，它隔离市电干扰高达40db 。 |
