| 1. | Survey on numerical simulation of weld pool
焊接熔池数值模拟的研究现状 |
| 2. | Vision detecting spray transfer pool and contour extraction
射流过渡熔池视觉检测与轮廓提取 |
| 3. | Numerical analysis of ternary alloy molten pool heated by electron gun
电子枪加热三元合金熔池的数值分析 |
| 4. | This signal can accurately indicate the keyhole condition in melting bath
该信号能准确反映熔池小孔的状态。 |
| 5. | Data extraction methodology of molten pool front - side geometrical parameters and back - bead width
焊接熔池正面几何参数和背面熔宽的数据提取方法 |
| 6. | Research on the influence of the depth of slag pool on the depth of metallic bath using fem in the process of electroslag casting
电渣熔铸中渣池深度对金属熔池深度影响的有限元模拟 |
| 7. | Abstract : in this paper , solidification process of laser pool for compositecoating system is studied , using numerical technology
文摘:采用数值模拟技术研究了复合涂层激光熔池凝固过程。 |
| 8. | In order to keep the normal bath temperature and slag forming condition , the charge of pig iron should not be exceeded 10 % on middle and small converter
中小型转炉内生铁块的加入量不应超过10 % ，使转炉吹炼过程中保持正常的熔池升温和成渣状况。 |
| 9. | A theoretical formula was applied to this process so that the open circuit voltage could predict the limit of deoxidization reaction
通过电池电动势与时间关系的数学模型，得出外电路电压与熔池中氧含量的关系，从而根据外电路电压可以预测脱氧反应进行的程度。 |
| 10. | At quasi - state stage , the depth and rad ius of laser pool have small changes , but the highest surface temperature and velocity of molten pool decease rapidly
在凝固准稳态阶段，熔池熔深和半径变化较小，但表面最高温度、熔池流速急剧减小；凝固加速阶段则反之。 |
