| 1. | A thermocouple is attached to the sample from above, to give a direct measurement of the temperature .
热偶从上面伸向试样，给出温度的直接测量。 |
| 2. | Simulation study of petlyuk system for alkyl distillation
烷烃分离热偶精馏的模拟研究 |
| 3. | Alloy wires of extension and compensating cables for thermocouples
热偶用补偿导线合金丝 |
| 4. | The oxygen probe can be classified as 1090 ( s ) and 1390 ( r ) by thermocouple international standardized type
定氧探头根据热偶型式可分为1090 （ s ）型定氧探头和1390 （ r ）型定氧探头。 |
| 5. | The problem may be minimized by mounting wire wound resistors to ensure that temperature differentials are minimized
调整电阻的安装方式，尽量降低两端的温度差异，可以降低热偶误差。 |
| 6. | Thermally coupled distillation can save 30 % energy and reduce capital investment compared with conventional distillation processes
摘要热偶精馏比常规精馏流程节能30 % ，还可降低设备投资。 |
| 7. | Combination probes for temperature and sample can be classified as 1090 （ s ） and （ r ） by thermocouple imternational standardized type
测温取样复合探头根据热偶型式可分为1090 （ s ）型和1390 （ r ）型。 |
| 8. | The temperature rises and the dc voltage are proportional to the power dissipated , which is equal to the power of the source being measured if the input impedance is suitably matched to the source impedance
热偶冷热结之间的温度差和热电势均正比于耗散在ta2n电阻上的微波功率，如果热偶的工作电阻与同轴传输系统电阻匹配适当，该功率就等于被测源的功率。 |
| 9. | The chip of microbridge structure thermocouple type microwave power sensor is designed by using seeback domino offect of thermocouple . ta2n of relatively low resistor - temperature coefficient and si of relatively high thermoelectric power seebeck coefficient are used as thermocouple materials in the chip
微梁结构热偶微波功率传感器芯片就是利用热偶的塞贝克效应设计的，芯片选择具有低电阻温度系数的ta2n和具有高热电系数的半导体单晶si作为热偶材料。 |
| 10. | 4 . the thrust measurement device was calibrated , and the accuracy was 2 % fs . at the same time the signal of thrust measurement was input to the computer . e - type chromel - constantan thermocouple was used to measure the temperature of mpt , and the accuracy was 5 % fs . the vacuum measurement was realized by using zdf - 5427m vacuometer , and the accuracy was 3 % fs
( 4 )对推力测量系统进行了标定并实现了计算机采集，推力测量系统最大相对误差为2 fs ；温度测量目前还只限于对mpt谐振腔壁温的测量，使用e型镍铬?康铜热电偶即可较容易实现，其测量精度为5 fs ；真空测量采用zdf - 5427m微机型复合真空计，其由热偶计和热阴极电离计复合而成，该真空计测量控制精度为3 fs 。 |
