| 1. | Apply less wet film thickness . increase pressure
减少湿膜厚度，加大压力。 |
| 2. | Test methods for measurement of wet film thickness of organic coatings
有机涂层湿膜厚度的测试方法 |
| 3. | Standard practice for measurement of wet film thickness by notch gages
刻痕量规测定湿膜厚度的标准实施规程 |
| 4. | Influence of technological parameters on the humidity controlling properties of pan bentonite intercalation composites
插层复合调湿膜的性能 |
| 5. | The wet layer of film shall be immediately measured with a wet film thickness gauge after the paint is applied
在涂装结束后，应立即用湿膜计对湿膜进行厚度测量。 |
| 6. | If the required paint film thickness has not been achieved , the additional coats should be applied till the specified thickness is attained
如果未达到要求的湿膜厚度，应覆涂直到满足指定的湿膜厚。 |
| 7. | The system can carry out such works as follows : acquisition of humidity states in the air should be carried out and the humidity should be sent to main control module
本文以湿膜式工业加湿器为控制对象，完成了湿膜式工业加湿器电控系统的设计。 |
| 8. | The humidification mechanism and humidification capability have been analyzed in theory . this is the foundation of design of electronic control system
对湿膜式工业加湿器的加湿机理和加湿性能进行了理论上的分析，为电控系统的设计奠定了基础。 |
| 9. | Firstly , choose an appropriate solution system to make a steady solution , and then limn2o4 film precursor was prepared on stainless steel by spin coating method with the solution
在前驱体溶液体系选择过程中,确定了最佳前驱体溶液体系组成;在最佳的前驱体溶液组成体系下,采用旋转涂覆法在不锈钢基体上制备前驱体湿膜。 |
| 10. | Under research in theory , this paper suggests that we should use such humidification method as follows : the vapor in humidifier should get across a roundabout room before it is sent to air . so the big beads in the vapor are deposited , and then the humidification will be even . 3
通过理论上的研究本文建议使用如下加湿方法：湿膜式加湿器中风机吹出的水蒸气不直接进入空气中，而是经过一个迂回的空间再送到空气侧，使水蒸气经过此空间后，其中较大的水珠沉积下来，从而较好的实现均匀加湿。 |
