| 1. | Total stress approach of shear strength
抗剪强度总应力法 |
| 2. | Total stress strength parameter
总应力强度参数 |
| 3. | Total stress failure envelope
总应力破坏包线 |
| 4. | Total stress analysis
总应力分析 |
| 5. | Approach to determine the total shear strength of unsaturated expansive soil and its application
非饱和膨胀土总应力强度的确定方法及其应用 |
| 6. | This thesis induced the expression of stress in pipe wall caused by all kinds of out load
结合规范，本文推导了在不同形式的外力作用下，管壁内应力的表达式，并得出了总应力的计算通式。 |
| 7. | A series of consolidated un - drained triaxial tests with equal consolidation ratio and equal shear are done for undisturbed loess q3 samples from longxi region of gan - su province
摘要用总应力法研究了应力路径对陇西q3原状黄土的固结不排水剪强度的影响。 |
| 8. | The relationship among the three kinds of stresses was discussed as well as the spot of maximum stress and its varying tendency with the time was obtained
讨论了热应力、机械应力对汽包总应力的影响及其相互关系，找出了锅炉在几种工况下最大应力点处的位置及其应力值随时间的变化规律。 |
| 9. | When earth pressures are calculated by the shear strength parameters of cu , the way water - soil calculating separately is best , which should involve the influences of excess pore water pressure through the total stress unloading strength parameters of cu
当采用固结不排水抗剪强度指标计算土压力时，最好采用水土分算的计算方法，计算时可以通过三轴固结不排水总应力强度指标将超静孔隙水压力的影响考虑在其中，但此时最好采用卸载强度指标。 |
| 10. | Based on the boundary conditions of the running parameters and test data of 125 mw boiler drum , the transient thermal stress , mechanical stress and whole stresses of the boiler drum under four different working conditions were computed by finite element methods under 3 - dimension model
摘要利用某电厂125mw锅炉机组的多次试验和机组故障所采集的数据作为三维有限元模型的边界条件，计算了该锅炉汽包模型在4种不同工况下的瞬态热应力、机械应力及总应力。 |
