Chinese translation for "循环软化"
|
- cycle-dependent softening
cyclic softening
Related Translations:
细胞壁软化: softening of the cell wall 软化度: degree of softensoftening degreesoftness numbersoftness value
- Example Sentences:
| 1. | Constitutive model for cyclic softening behavior of 45 steel under uniaxial cyclic straining
45钢单轴应变循环软化行为的本构模型 | | 2. | The second stage is a cyclic softening course , and what ' s more , the greater the strain amplitude , the greater the trend of softening
在所有试验条件下合金的疲劳硬化阶段都很短暂，疲劳寿命的极大部分是消耗在缓慢的循环软化阶段。 | | 3. | It can be noticed that both r and t specimens show initial hardening and subsequent softening at the strain amplitude higher than 0 . 8 % and cyclic softening from the beginning to fracture under strain amplitude less than 0 . 8 % at room temperature , and the cyclic flow stress was always lower in r specimen than in t specimen at the same strain range
且在相同的应变幅下， t向试样比r向试样具有更高的循环流变应力。此外，对r向及t向试样，低应变幅下呈现出循环软化现象是因为晶粒旋转导致循环软化；而在高应变幅下发生循环硬化是由于孪晶作用的结果。 | | 4. | For the cyclic deformation under a given strain at room temperature , cyclic softening is usually displayed till to failure in the lower range of strain ; however , cyclic hardening is displayed in the early stage in the higher range of strain , subsequent cyclic softening in the later stage and till to failure
对于室温下恒应变幅的循环变形，在应变幅较低时表现为循环软化直至疲劳破坏;在应变幅较高时，循环变形的初期为循环硬化，随后是循环软化直至疲劳破坏。 | | 5. | The alloys , which were cold - worked followed by recrystallization annealing , display cyclic softening in the range of low strain because the cyclic stress - strain curve lies below the monotonic stress - strain curve , and show cyclic hardening in the range of high strain because the cyclic stress - strain curve lies above the monotonic stress - strain curve
在低应变范围，冷加工后经再结晶退火处理的错合金的循环应力一应变曲线位于单调拉伸曲线的下方，表现为循环软化;在高应变范围则位于单调拉伸曲线的上方，表现为循环硬化。 | | 6. | And finally , sem has been used to characterize the fracture . the results indicate that the relationship between the fatigue lifetime and cyclic plastic strain range obeys coffm - manson relation , and the relation between the hysteresis energy ( wn ) and the plastic strain range ( p ) can be described by a power - law : wh = h pw
但在室温下， r向及t向试样具有相同的循环特性，均表现为随应变幅的不同而不同，当应变幅高于0 . 8时，呈现出先循环硬化而后循环软化直至最后断裂的现象。 | | 7. | The experimental results is shown as followings : ( 1 ) the cyclic flow stress - strain curves in an incremental step test could be expressed as the power law relation : ( 2 ) when the strain amplitude is lower during cyclic deformation tests under constant strain control , softening firstly appears , then gradually hardens with the increasing numbers of cycle ; when the strain amplitude is higher , hardening firstly appears , then gradually softens
试验结果表明： ( 1 )循环流变应力与应变的相互关系曲线均符合幂律关系式： ( 2 )在室温下进行恒应变幅循环变形过程中，当所控制的应变幅较小时，该材料首先出现循环软化，之后随循环周次的增加直至循环失效前该材料出现了硬化现象。当应变幅较大时，该材料开始出现硬化，然后随循环周次的增加才出现软化。 |
- Similar Words：
- "循环冗余校验字符" Chinese translation, "循环冗余字符" Chinese translation, "循环冗作检验" Chinese translation, "循环冗作检验寄存器" Chinese translation, "循环冗佘校验" Chinese translation, "循环润滑" Chinese translation, "循环润滑法" Chinese translation, "循环润滑系统" Chinese translation, "循环润滑油" Chinese translation, "循环润滑油柜" Chinese translation
|
|
|
