| 1. | Reporting cure times of ultraviolet - cured coatings
紫外线固化涂料固化时间的报告 |
| 2. | Testing method for setting time of refractory mortars
耐火泥固化时间的试验方法 |
| 3. | Test method for determining stroke cure time of thermosetting phenol - formaldehyde resins
热固性酚醛树脂冲击固化时间的测定 |
| 4. | Rate of cure and final strength will depend on the resistance time at the cure temperature
固化比率及最终固化强度取决于在固化温度条件下所持续的固化时间。 |
| 5. | Method of test for hydraulic setting floor smoothing and or levelling compounds - determination of setting time ; german version en 13409 : 2002
液压固化地板平整复合物的试验方法.固化时间测定;德 |
| 6. | After the electrophoresis , the magnets should be solidified on the low temperature firstly , then solidified in the high temperature
电泳后应先低温烘烤去除水分，然后高温固化；合适的固化温度是170左右，合适的固化时间为20min左右。 |
| 7. | The curing of the magnets always in the vacuum circumstance . as far as the mixture cohesion is concerned , the optimized curing temperature and time are 120 and 120min
所用粘结剂合适的固化温度是120 ，合适的固化时间是120min ，固化后磁体应该随炉冷却。 |
| 8. | The research of phenol - formaldehyde ( pf ) resin modified with lac can be expected to widen the application of the lac and enlarge the utilization of the renewable resource
研究了对紫胶改性酚醛树脂胶粘剂的固化时间、粘接胶合板的粘接强度和甲醛释放量进行了测定。 |
| 9. | The curing time of the modified pf resin and the adhesive strength and emission of formaldehyde of the plywood bonded with this modified pf resin was measured in this paper
结果表明:紫胶改性酚醛胶的固化时间与普通酚醛胶接近,粘接胶合板的粘接强度达到类胶合板的要求,胶合板的甲醛释放量降低。 |
| 10. | Low temperature flexible , easily pourable rtv silicone sealant / encapsulant , can be used with a wide variety of curing agents , thus varying pot life , cure time , mix ratios and cure conditions
低温弹性，易浇注的rtv密封硅胶，可与多种固化剂使用，可改变灌胶时间、固化时间、混合比率以及固化条件。 |
