Mobile
Log In Sign Up
Home > english-chinese > "喷管出口面积" in Chinese

Chinese translation for "喷管出口面积"

exhaust jet area
nozzle exit area


Related Translations:
涡轮喷管:  turbine nozzle
低速喷管:  slow running jet tubeslow-running jet tube
铰接式喷管:  hinged nozzle
喷管端点:  end of the nozzle point
喷管倾斜:  cant of the jet
可变喷管:  variable nozzle
膨胀喷管:  expansion nozzle
喷管根部:  nozzle-end
反向喷管:  reversal nozzle
喷管架:  nozzle tube yoke
Example Sentences:
1.The conclusion that the optimal secondary nozzle exit area generating the maximum thrust agrees well with the numerical simulation , indicating that the exit area of secondary nozzle should be optimized according to structure and flow parameters during design
表明在引射火箭设计时,应结合引射火箭的结构和流动参数对二次喷管出口面积进行优化设计,以达到最佳推力性能。
2.The results indicate that with decrease of exit area of secondary nozzle , the bypass ratio is decreasing , and the static pressure in integrated ejector combustor is increasing , and mixing condition becomes better . there exists an optimal exit area of secondary nozzle to get maximum thrust of rocket ejector
结果表明:引射能力随着二次喷管出口面积的减小而减小;整体式引射燃烧室压强随着二次喷管出口面积的减小而上升,混合随之更为充分;存在一个最优的二次喷管出口面积,使发动机推力最大。
3.It is shown that when the exit area of secondary nozzle and the fuel / oxidizer ratio is fixed , the increase of mass flow rate of secondary flow lead to the decrease of velocity of mixed flow , and increase of total mass flow rate . the synthetical result of these two phenomenon cause the increase of thrust of rocket ejector , but the increasing magnitude is relatively small , indicating that these is no necessary to claim large bypass ratio in rocket ejector design . in the comparison between two configurations , the typical one has better performance , indicating the importance of pressure ratio
结果表明:在固定二次喷管出口面积和氧燃比的条件下,二次流(引射空气流)流量的增加引起混合气体出口速度的下降和总流量的增加,二者综合作用使发动机推力增加,但增幅不大,表明在设计发动机结构和工作参数时,不必过分追求大的引射系数;两种结构的性能对比分析表明了增压比对引射火箭性能的提高具有重要意义;对引射火箭的热力循环分析同样表明,增压比对于提高发动机性能非常关键。
4.The experimental results indicates that the secondary mass flow increases with increasing of primary mass flow rate , but the bypass decrease because the primary mass flow rate increase more rapidly than secondary mass flow . the expansion configuration shows low thrust property due to low pressure in flow path . the secondary nozzle changes the pressure distribution in ejector combustor , and decreases bypass ratio , but obtain more completely mixing
结果表明:二次流流量随着一次流流量的增加而增加,由于二次流流量的增加速度低于一次流,引射系数减小;在纯扩张式结构实验中,引射燃烧室压强很低,难以实验推力增强;二次喷管改变了引射燃烧室的压强分布,降低了引射系数,改善了混合状况能;对于本文的实验结构,存在一个最优的二次喷管出口面积,使引射火箭推力最大,同数值模拟结果相吻合。
Similar Words:
"喷管出口角" Chinese translation, "喷管出口截面" Chinese translation, "喷管出口截面面积" Chinese translation, "喷管出口马赫数" Chinese translation, "喷管出口面" Chinese translation, "喷管出口切角" Chinese translation, "喷管出口速度" Chinese translation, "喷管出口条件" Chinese translation, "喷管出口压力" Chinese translation, "喷管出口直径" Chinese translation