| 1. | Thickness of blow film and the design of its control system
吹塑薄膜厚度检测与厚度控制系统设计 |
| 2. | Application of neutral network in plastics thickness control system
神经网络在薄膜厚度控制系统中的应用 |
| 3. | Intelligent thickness control based on neural network fuzzy inference
基于神经网络模糊推理的智能厚度控制 |
| 4. | First time coating thickness is 1 - 1 . 5mm , then it is limited to 2 - 3mm , coat it each time with 24 - hour interval time until reaching the stated thickness
5mm ，以后每次施涂厚度控制在2 3mm以内，每隔24小时涂一次，直至规定厚度。 |
| 5. | Our products are also in widespread use as sensors for the automatic thickness control systems of some of japan s leading extrusion machine manufacturers
并且，作为国内大型挤压膜塑机厂商的自动厚度控制系统的传感器被广泛地采用。 |
| 6. | First time coating thickness is 1 - 3mm , then it is limited to 5 - 8mm , coat it once each time with 24 hours interval time until reaching the stated thickness
第一遍施涂厚度1 3mm ，以后每次施涂厚度控制在5 8mm以内，每隔24小时施涂一次，直至规定厚度。 |
| 7. | Film build control one should control the thickness according to our company ' s requirement . different thickness of powder coatings has different appearance . it may has waves or orange peel
厚度控制：应按照本公司厚度要求控制，因为，有些粉末在不同厚度下，其板面效果会产生波动。 |
| 8. | A method of getting effective microcavity length by measuring microcavity emitting modes , which can direct the controlling of thickness of organic layers , is put forward
指出光学极值法可以可靠地避免这种影响。介绍通过微腔发光模式确定有效腔长，可方向性指导有机薄膜的厚度控制。 |
| 9. | The paper introduces the development of the thickness control technology for strip mill , and reasons affecting thickness variation , and discusses the principle of agc control on cold mill , the algorithm and characters
摘要介绍板带轧机厚度控制的发展及影响板带厚度波动的原因；分析、讨论冷轧机应用的各种agc的控制原理、控制算法以及各自的特点。 |
| 10. | A control system for the thickness of ion beam sputter ( ibs ) coating is introduced in this paper . the basic principle of ibs coating machine is discussed . this paper also gives the scheme of hardware and sofeware
本文介绍了离子束溅射镀膜机膜厚控制的一种实用的系统，文中论述了离子束溅射镀膜机的工作原理及镀膜厚度控制系统的硬、软件的实现方案。 |
