Chinese translation for "单体浓度"
|
- monomer concentration
Related Translations:
单体烧结: burden-fluxing sinter 单体配比: comonomer ratiomonomer ratio 单体两性生殖: ampherotokyamphitokyamphoterotoky 单体电容器: monolithic capacitor
- Example Sentences:
| 1. | Influence of different polymeric conditions , such as initiator concentration - > monomer concentration , temperature , t ime > solvent , on polymerization of monomers were investigated in detail
详细研究了聚合条件(引发剂含量、单体浓度、聚合温度、聚合时间、溶剂)对聚合反应的影响。 | | 2. | Atr - ir , xps and colorimetric method were used to characterize the grafting density of the hydrophilic polymers on the plla membranes , which increased with the monomer concentration and the grafting time
采用atr - ir 、 xps和比色法表征了plla膜表面亲水性聚合物的接枝量，结果表明接枝量随单体浓度的提高和接枝时间的延长而增大。 | | 3. | High performance nanofiltration composite membrane with varied permeating flux and salt rejection was obtained by changing the monomer concentrations in both phases properly . in the case of composite membrane ( ii ) , the concentration of organic phase was enhanced to 0 . 5 %
改变两相单体浓度可以获得不同通量和脱盐性能的纳滤复合膜，如适当提高有机相浓度至0 . 5得复合膜( ) 。 | | 4. | Based on the theory of synthesis in inverse emulsion , five factors to influence the viscosity of product and the stability of the system were studied , such as the ratio of volume of oil to water , the type of emulsifiers , the type of initiators and the ratio and concentration of dac to am
讨论了引发剂种类、乳化剂种类、单体浓度及配比、油水体积比等因素对共聚产物的特性黏度和体系稳定性能的影响，确定了最佳反应条件。 | | 5. | Only on the surfaces with moderate hydrophilicity could the cell have a polygonal shape and spread well . on the control plla and the grafted plla membranes with high density of hydrophilic polymers the cells were round shape and aggregated with each other to form cell aggregates
通过改变单体浓度和接枝时间，制备了一系列不同接枝量的plla - g - paam和plla - g - pmaa平面膜，并考察了材料表面不同的官能团以及材料表面的亲水性对细胞铺展性能的影响。 | | 6. | The concentration of pyrrole , the concentration of the enzyme , the ph of solution , and the volume of charge had a great effect on the preparation of the electrode . when the concentration of enzyme was 2mg / ml , the concentration of pyrrole was 0 . 05m , the concentration of liclo4 was 0 . 05m , the ph of solution was 5 . 0 , the polymerization potential was 0 . 8v ( vs . sce ) and the volume of polymerization charge was 2 . 5mc , the response of polypyrrole / glucose oxidase electrode was high
实验发现聚吡咯溶液中吡咯单体的浓度、酶的浓度、聚合溶液的ph值、聚合电量等对电极的响应影响较大，当酶的浓度为2mg ml ，吡咯单体浓度为0 . 05m ， liclo _ 4的浓度为0 . 05m ，聚合溶液的ph为5 . 0 ，聚合电位为0 . 8v ( vs . sce ) ，聚合电量为2 . 5mc时，制备的酶电极的响应最大。 | | 7. | The content of styrene was found to be dependent on the investigated grafting conditions , of which the dose rate and monomer concentration were the major conditions , and the dependence of the initial rate of grafting on the dose rate and the monomer concentration was found to be of 0 . 4286 and 1 . 1662 orders , respectively . the results indicate that the grafting reaction is competitive and the copolymerization and the graft - copolymerization are existing at the same time . the grafting proceeds by the so - called front mechanism in which the grafting starts at the surface of the films and moves toward the middle of the film by successive diffusion of the styrene through the grafted layers
我们对辐射接枝反应中的各个因素如：单体浓度、辐射剂量率、辐射剂量以及反应时间进行了研究分析，结果表明：单体浓度和剂量率是反应的两个主要影响因素，它们对反应速率的影响指数分别为1 . 1662和0 . 4269 ；反应的动力学方程为： rg k [ d ] ~ ( 0 . 4269 ) [ m ] ~ ( 1 . 1662 ) ；认为接枝反应是一竞争反应，单体的均聚反应和在聚合物上的接枝反应同时存在，单体浓度的高低决定着竞争反应的方向；辐射接枝反应是从聚合物表面开始的，随着溶剂的溶胀和单体的扩散最后在整个膜体中形成接枝产物。 | | 8. | The emphasis of this article is studying the influence of the polymer net in the clc to the reflected spectrum . at the same time , under the laboratory condition in possession , a design scheme of manufacturing psct with better planar structure , which needn ’ t orienting and rubbing , is found out by optimizing the craft condition like the species of polymer monomer , the concentration of monomer , the polymerization conditions ( temperature , time , uv light intensity )
本论文的重点是研究胆甾相液晶中聚合物网络对反射谱特性的影响,在实验室现有的条件下,通过改变聚合物单体材料、聚合物单体浓度及聚合条件(紫外光光强、光照时间、聚合温度) ,并结合一定的理论指导和实验现象分析,找出了一种制作具有较好平面取向的psct的设计方案。 | | 9. | And the adsorbability of this novel adso rbent for ldl was determined . in order to prepare the solid supports in accordance with with the request of adsorbent for ldl , paam beads were synthesized by inverse suspension polymerization . the composition of the polymerization system is shown as follows : the concentration of monomer and dispersant are 12 % and 0 . 65 % respectively , the volume ratio of oil / water isl : 3 , the mole ratio of aam and mba is 18 : 1
本文用反相悬浮聚合法合成符合ldl吸附剂载体要求的聚丙烯酰胺微珠，经实验筛选出反应体系所需的最佳单体浓度( 12 ) 、最佳分散剂用量( 0 . 65 ) 、最佳油水比值( 1 ： 3 ) 、最佳单体( aam )与交联剂( mba )的物质的量之比( 18 ： 1 ) 。 |
- Similar Words：
- "单体氯乙烯" Chinese translation, "单体滤器" Chinese translation, "单体酶" Chinese translation, "单体明" Chinese translation, "单体内径千分尺" Chinese translation, "单体判据" Chinese translation, "单体耪装置" Chinese translation, "单体配比" Chinese translation, "单体铺装" Chinese translation, "单体取向" Chinese translation
|
|
|
