Chinese translation for "tension-torsion"
|
- 拉、扭剪
Related Translations:
- Example Sentences:
| 1. | Using newly developed filament - wound composite tubular specimens , the tension - torsion biaxial loading fatigue tests were performed
同时设计出一种缠绕复合材料管状试样，进行了拉扭双轴疲劳实验研究。 | | 2. | It is not yet very known especially of the mechanical behaviour after secondary hardening such as torsion - tension - tension and tension - torsion - tension
特别是在扭转-拉伸-拉伸和拉伸-扭转-拉伸等二次硬化后的a3钢的力学性能还不甚了解。 | | 3. | The mechanical behaviour of a3 steel specimen under monotonic tension , pure torsion , torsion - tension , tension - torsion , torsion - tension - tension , tension - torsion - tension were studied by standard cylinder specimen in this paper
本文研究了a3钢试件在单一拉伸、纯扭转时的力学性能；在拉伸-扭转、扭转-拉伸时的力学性能；在扭转-拉伸-拉伸、拉伸-扭转-拉伸时的力学性能。 | | 4. | Comparing with these several strengthen formal , towards strength limit ' s improvement , the effect of torsion - tension and tension - torsion - tension was close ; simply tension - torsion - tension required a little larger prestrain quantity . whereas , towards yield limit " s improvement , the effect of torsion - tension - tension action ' s strengthen was the best
从几种硬化形式的比较来看，对于强度极限的提高，扭转-拉伸和拉伸-扭转-拉伸的强化效果相近，只是拉伸-扭转-拉伸所需的预应变量要大一些；而对于屈服极限的提高，扭转-拉伸-拉伸作用下的强化效果最佳。 | | 5. | When the a3 steel specimen was operated by tension - torsion - tension action , both the yield limit and strength limit had very large improved compared with that of monotonic tension . the improve scope of the yield limit could be 109 . 36 % , the strength limit could be 56 . 26 % . the yield limit value reached the max
A3钢试件在拉伸-扭转-拉伸作用下的力学性能与单一拉伸相比，试件的屈服极限和强度极限都有很大提高。屈服极限提高幅度最高可达109 . 36 ，强度极限提高幅度最高可达56 . 26 。 | | 6. | After pretorsion the successor tensile yield limit and strength limit both improved very highly , but the trend of the increase of the strength limit was suspended till the pretorsional capacity reached 17 , when the pretorsional capacity was greater than17 ( prestrain value was 81 . 19 % of total strain ) , the successor strength limit rapid failed and approached the yield limit . this illustrate the a3 steel specimen translate from plasticity into friability after pretorsion strengthen . when the specimen was operated by tension - torsion action , the yield limit had very large improved , but the strength limit changed very little . furthermore , the trend of the increase of the strength limit was suspended till the pretension capacity reached 0 . 25 ( prestrain value was 66 . 93 % of total strain )
A3钢试件在预扭转后，后继拉伸屈服极限和强度极限均有很大提高，但强度极限的增大趋势到预扭转量为17为止，预扭转量大于17 (预应变值为总应变的81 . 19 )后强度极限迅速下降，与其屈服极限接近，这说明a3钢试件经预扭转强化后逐渐由塑性转化为脆性。该预应变值为a3钢试件的韧脆转变点。 a3钢试件在拉伸-扭转作用下，屈服极限有很大提高，但强度极限没有多大改变，而且，屈服极限的增大趋势到预拉伸量为0 . 25应变(预应变量为总应变量的66 . 93 )后就不再增加。 | | 7. | Consider the total plasticity of these several kinds of prestrain a3 steel specimen . the total plasticity of tension - torsion - tension action was higher than that of torsion - tension and torsion - tension - tension action . but the max . values of their total plasticity were all greater than those of any single destructional form
考虑几种预应变下的a3钢试件的总塑性，拉伸-扭转-拉伸作用下的总塑性比扭转-拉伸和扭转-拉伸-拉伸作用下的总塑性有明显的提高。但它们的总塑性的最大值都大于单一破坏形式下的总塑性。 |
- Similar Words：
- "tension-set packer" Chinese translation, "tension-stress effect" Chinese translation, "tension-tension fatigue strength" Chinese translation, "tension-tension test" Chinese translation, "tension-time index" Chinese translation, "tension-type hanger" Chinese translation, "tension-type load cell" Chinese translation, "tension-vascular headache" Chinese translation, "tension-velocity curve" Chinese translation, "tension-velocity relation" Chinese translation
|
|
|
