Mobile
Log In Sign Up
Home > english-chinese > "外加载荷" in Chinese

Chinese translation for "外加载荷"

applied loadings
externally applied load


Related Translations:
外加作业:  busy work
外加压力:  applie pressureapplied pressureextra pressureimpressed pressure
外加步:  extra step
外加推力:  applied thrust
外加功率:  applied power
外加晕:  superimposed halos
外加热:  externally heated
外加力:  applied forcecompelling force
外加电压:  applied pressureapplied voltageexternal voltageimpressed voltageimpressed-voltage
外加冲击:  applied shock
Example Sentences:
1.The results show that with the increase of loads , the mass loss of roller increases considerably , with the increase of roller ' s hardness , the main wear mechanism changes from plastic deformation wear to ploughing wear
结果表明,随着外加载荷的增大,轮子磨损加剧,随着轮子硬度增加,主要磨损机理从塑变磨损转变为犁沟磨损。
2.Four contact state depending on rate of rolling / sliding between the couple of contact element were studied based on hertz contact model , and the results was shown that the rate of slide would affect the distribution of pressure in contact area and stress in the half plane
研究表明安定状态随载荷的大小而变化,其残余应力和应变累积的大小与外加载荷成正比,并对计算中的一些问题进行了分析探讨。
3.The effect of supporting roller ' s hardness and loads on the roller was investigated by the mean of reasonable wear experiment in laboratory , wear mechanisms of supporting roller was researched and observation of their worn surface by scanning electron microscope
摘要采用试验室试样磨损试验方法,在合理的实验条件下,考查了支重轮硬度及外加载荷对磨损量的影响,用扫描电镜观察试样磨损表面形貌并分析其磨损机理。
4.The effects of pitch angle , rolling angle , pad velocity , rotation speed and standard nominal clearance on load and moments were obtained by analyzing the numerical results , and the effects of external load , external moments ( x - axis and y - axis ) , rotation speed and pad velocity on fluid pressure distribution , on tilt angles , azimuth angle and standard nominal clearance are further studied . the reason for the existence of negative pressure in ctp and its effect on the polishing result was discussed . it is proved that ctp can achieve the best
通过对仿真结果的分析,给出了工件倾角、转角、抛光速率、角速度及中心膜厚等主要研抛参数变化时工件的承载能力变化,也即压力积分载荷、压力转矩的变化;分析了外加载荷、 x / y轴转矩、抛光速率、角速度变化对加工过程中工件偏转角、方位角及中心膜厚的影响;讨论了全膜接触模型中负压产生的原因及对研抛结果的影响。
Similar Words:
"外加源无损测试" Chinese translation, "外加源有损测试" Chinese translation, "外加晕" Chinese translation, "外加杂质" Chinese translation, "外加载" Chinese translation, "外加载荷应力" Chinese translation, "外加噪声" Chinese translation, "外加蒸气压力" Chinese translation, "外加指点标" Chinese translation, "外加指令" Chinese translation