外加载荷 meaning in Chinese
applied loadings
externally applied load
Examples
- The results show that with the increase of loads , the mass loss of roller increases considerably , with the increase of roller ' s hardness , the main wear mechanism changes from plastic deformation wear to ploughing wear
结果表明，随着外加载荷的增大，轮子磨损加剧，随着轮子硬度增加，主要磨损机理从塑变磨损转变为犁沟磨损。 - Four contact state depending on rate of rolling / sliding between the couple of contact element were studied based on hertz contact model , and the results was shown that the rate of slide would affect the distribution of pressure in contact area and stress in the half plane
研究表明安定状态随载荷的大小而变化，其残余应力和应变累积的大小与外加载荷成正比，并对计算中的一些问题进行了分析探讨。 - The effect of supporting roller ' s hardness and loads on the roller was investigated by the mean of reasonable wear experiment in laboratory , wear mechanisms of supporting roller was researched and observation of their worn surface by scanning electron microscope
摘要采用试验室试样磨损试验方法，在合理的实验条件下，考查了支重轮硬度及外加载荷对磨损量的影响，用扫描电镜观察试样磨损表面形貌并分析其磨损机理。 - The effects of pitch angle , rolling angle , pad velocity , rotation speed and standard nominal clearance on load and moments were obtained by analyzing the numerical results , and the effects of external load , external moments ( x - axis and y - axis ) , rotation speed and pad velocity on fluid pressure distribution , on tilt angles , azimuth angle and standard nominal clearance are further studied . the reason for the existence of negative pressure in ctp and its effect on the polishing result was discussed . it is proved that ctp can achieve the best
通过对仿真结果的分析,给出了工件倾角、转角、抛光速率、角速度及中心膜厚等主要研抛参数变化时工件的承载能力变化,也即压力积分载荷、压力转矩的变化;分析了外加载荷、 x / y轴转矩、抛光速率、角速度变化对加工过程中工件偏转角、方位角及中心膜厚的影响;讨论了全膜接触模型中负压产生的原因及对研抛结果的影响。