剪切速度 meaning in Chinese
rate of shear
shear velocity
shearing velocity
Examples
- 2 % 22 % and 29 % respectively less than using other three knives at cutting speed of 500mm / min when the moisture contents of rootstalks was 48 . 2 % . the cutting forces were tested at four different parts of rootstalk that were the middle part along a radius , the tip part along a radius , the middle part along axis and the stalk part along a radius , and the force at the middle along a radius is the largest and increase 32 % 45 % 111 % , respectively more than at the other three parts . the force increase 37 % to cut the rootstalks from the areas one crop a year more than that from two crops a year
试验结果表明,根茬含水率愈高,剪切力愈小,根茬含水率与剪切力近似为二次曲线关系;刀片剪切速度愈快,剪切力愈小;凸曲线、斜线、凹曲线和直线四种不同的刀刃曲线对整株根茬剪切力依此由小到大,凸曲线和斜线剪切时有一定程度的滑切作用,所以剪切力相比较小,当根茬含水率为48 . 2 ,剪切速度500mm min时,与其他三种曲线相比凸曲线型刀刃的剪切力依次分别减少了7 . 2 、 22和29 ;对根茬中部、梢部和根部的剪切力,在相同试验条件下,径向中部最大,比梢部,轴向根部和根部茎秆所需剪切力分别增加32 、 45和111 ;当含水率为48 . 2 ,刀片的剪切速度为500mm min时,一年一熟玉米根茬比一年两熟的玉米根茬剪切力增大37 。 - The unit is hydraulically controlled . feeding , shearing , coiling of it adopt imported frequency regulating or dc motor control . the shearing uses mobile bent . the transfer and adjusting of cutters do not have to dismantle cutter holder . with high automation and easy opwration , the shearing speed reaches 0 - 50m / min . adopting imported cutter and holder , it reaches a speed of 0 - 150m / min
全机组采用液压控制,剪切,收卷动力采用进口变频控制或直流电机控制.剪切采用移动式排坊,换刀,排刀需拆卸刀轴,自动化程度高,操作方便,剪切速度每分钟0 - 50米.用进口刀片刀垫每分钟可达0 - 150米 - One new type double backspin rotor type sand mixing machine passes technique appraisal of qingdao tianheng machinery co . , ltd . this machine adopts double rotor configuration researched internationally ; the rotor is installed on different output axis of same reducer , which produces comparative cross cutting speed by using rotors with different speed that makes sands get strong cutting and friction force . therefore , it can reduce clay and quicken sand mixing
一种新型双逆转子式混砂机在青岛天恒机械有限公司通过技术鉴定,该机采用国际首创的双转子结构,其转子安装在同一减速器的不同输出轴上,利用两个轴的不同转速使转子间产生相对交叉剪切速度,使砂子受到的冲剪及搓擦力加强,从而减少粘土团,加快砂子的混合。