| 1. | Real beds with internals and with aspect ratios not much larger than unity should satisfy these requirements rather well .
具有内部构件的真实床层，其高宽比1不太大于1时，应该可以相当好地满足这些要求。 |
| 2. | Gets the maximum texture aspect ratio supported by the hardware
获取硬件支持的最大纹理高宽比。 |
| 3. | This method is often used to change the aspect ratio of a video stream
此方法通常用于更改视频流的高宽比。 |
| 4. | The maximum texture aspect ratio
最大纹理高宽比。 |
| 5. | In this paper , 31 specimens of concrete filled rectangular steel tube ( cfrst ) are tested under cycle loading , the main parameters are axial ratio , section height to width ratio and steel strength
考虑轴压比、高宽比、混凝土强度等参数，进行了31根矩形钢管混凝土压弯构件滞回试验。 |
| 6. | A lot of micro machining technologies are developed to fabricating memss . recently , lithograph of thick resist has been regarded as an effective and economical technology for manufacturing excellent high - aspect - ratio microstructures ( harms )
近年来，作为制作优质大高宽比微结构的厚层抗蚀剂光刻术以其工艺简单、制作成本低等优点受到国际上广泛重视。 |
| 7. | However the experience about design of high arch - darn is not enough in deep valley , especial when the dam is located in the areas of intensive earthquake . therefore the study of three dimension earthquake response is great significant in reality and history to the hydroelectric construction
然而，由于缺乏在河谷高宽比大的高拱坝设计经验，特别是在高地震烈度区修建高拱坝，因此，本项目的研究分析具有十分重要的现实意义。 |
| 8. | So its suggested that the ratio of building height and building width for the staggered truss steel framing is better less than 5 in the region of seismic fortification intensity is 7 and less than 4 in the region of seismic fortification intensity is 8
7 )通过高宽比对钢结构交错析架体系的整体延性的影响分析，建议在7度及以下抗震设防地区，钢结构交错精架体系的高宽比宜小于5 ;在8度抗震设防地区，钢结构交错析架体系的高宽比宜小于4 。 |
| 9. | Besides , with stated heightand brendth ratio , acted on by horizontal and vertical load , the ultimate loads of wall failed in bending - shear is similar to one failed in shear . the walls crack form is indefinite . we ca n ' t define consolidate menthod only by the crack from
另外，一定高宽比的砖墙在竖向与水平荷载联合作用下，当弯剪破坏与剪切破坏的极限荷载比较接近时，其破坏形式具有不定性不能简单地以裂缝形式确定加固方案。 |
| 10. | Both static and cyclic load tests are conducted for a same size specimen . the purpose is to find the effect on shear strength from different height - width ratio , and to get the shear resistance limit by static and cyclic loading . according to test results , the improvement suggestions for the wall details and design are presented in this paper
同样尺寸的二个试件分别在顶端进行水平单调加载和水平方向低周往复加载抗剪试验一次，试验目的是测试墙体的不同高宽比对抗剪强度的影响以及墙体在单调加载及低周反复加载两种情况下的抗剪强度pu并做出比较，从而对墙体构造及设计提出改进建议。 |
