| 1. | It would be necessary to connect a limiting resistor in series with the lamp .
须用一个限流电阻同灯泡串联起来。 |
| 2. | Clr current - limiting resistor
限流电阻器 |
| 3. | Current limiting resistance
限流电阻 |
| 4. | It is , of course , important to choose the resistor so that it neither degrades the noise performance of the system nor allows too much current to pass under fault conditions
因此，限流电阻的选择十分重要，既要限制故障电流，又不能引入太大的噪声。 |
| 5. | A new bridge type high temperature superconducting fault current limiter ( sfcl ) with a limiting impedance of superconductor serried in the limiting circuit is proposed , which could limit the peak value and the stable value of the fault current
摘要提出一种改进的桥式高温超导限流器拓扑结构，将不同高温超导体制成的限流电阻与限流电感同时申入桥式限流回路。 |
| 6. | When the signal source of an op - amp contains an energizing voltage which is much higher than the op - amp supply it is common to use a diode and a current limiting resistor to protect the op - amp in the event of a sensor short - circuit
为了防止信号源窜入高压损坏放大器，常见的做法是在放大器输入端到放大器电源间串接一个二极管，并且在放大器输入端串接一个限流电阻。 |
| 7. | The design of the circuit ? key parameters including pulse width in the level shifter part and delay time of the filter circuit , and the necessity to add a limiting current resistor at source the ldmos were emphatic analyzed . author finished the design of each sub - circuit
对电路关键参数高低压电平位移脉冲宽度、高端滤波电路滤波宽度的设计及在ldmos源端加入限流电阻的必要性进行了重点分析，完成了各单元电路的设计。 |
| 8. | In non - selfsustained discharge the excitation and ionization processes can be controlled separately , which is useful to optimize the e / p value of the discharge . the ballast resistance can be leaved out and the maximal electro - optical efficiency reaches 19 %
非自持放电使激光器的激发和电离过程分开，有利于使二者分别处于各自的最佳e p值附近，放电的正阻抗特性使放电电路可以省去限流电阻，极大地提高激光器的实际效率。 |
