English translation for "铸造碳化钨"
|
- cast tungsten carbide
Related Translations:
碳化铌: columbium carbideniobium carbide 铸造模子: casting dieo moulds for foundry 向心铸造: centripetal casting 离心铸造: centre die castingcentre diecastingcentre spinningcentrifugal castingcentrifuge castingrotary castingrotational castingspun casting
- Example Sentences:
| 1. | It is preferable to use tungsten carbide of fine grain size for such build - up welding 堆焊采用的铸造碳化钨颗粒,以细的为佳。 | | 2. | Cast tungsten carbide 铸造碳化钨 | | 3. | Their lifetime can be prolonged if they are repaired with cast tungsten carbide powder 采用铸造碳化钨修补后,可以延长使用寿命。 | | 4. | The age hardening characteristic of as - cast cu20ni20mn and cu20ni35mn alloys and the interface characteristic between the alloy and cast tungsten carbide were studied , and on the basis of this study , composites of cu - ni - mn alloy reinforced with different volume fraction ( 0 - 45vol . % ) and different size ( 42 - 362 m ) of cast tungsten carbide particles were made by vacuum hot - pressing liquid sintering technology . pin on disk two body abrasion tests have been performed with different size of sic abrasive under different loads 本文研究了铸态cu20ni20mn和cu20ni35mn合金的时效硬化特性及其与铸造碳化钨的界面特性,并在此基础上以不同尺寸( 42 362 m )的铸造碳化钨颗粒为增强体,采用真空热压液相烧结技术制备了不同颗粒含量( 0 45vol . )的铸造碳化钨颗粒增强cu - ni - mn合金基复合材料;以不同粒度的sic为磨料,在不同载荷条件下利用销?盘磨损试验机测试了复合材料的二体磨料磨损性能。 | | 5. | The results show that the composites were more wear resistant than the matrix , contributing to the " volume effect " and " size effect " , the wear resistance increases with the particle content and size . the composite shows better wear resistance than high chromium cast iron material especially in low load and fine abrasive test condition . the results also indicate that the composite strengthened by ageing treatment was more wear resistant than as - cast composite 磨损试验结果表明,铸造碳化钨颗粒增强cu - ni - mn合金基复合材料具有比较高的抗磨料磨损能力,而且其耐磨性随着铸造碳化钨颗粒体积分数及尺寸的增大而提高,表现出了强烈的“体积效应”及“尺寸效应” ,尤其是在低载荷、细磨料磨损条件下,复合材料表现出更好的而寸磨性,即使与高铬铸铁( cr28 )相比也有很大程度的提高。 | | 6. | The strength and wear resistance of diamond drill bits for petroleum exploitation will be increased considerably when cast tungsten carbide is applied and adheres to the substrate firmly with cast tungsten carbide of 80 - 200mesh as the skelton and copper alloy as the soldering material in a process of non - pressure immersion 石油钻探行业用的金刚石钻头,用粒度为80 ? 200目的铸造碳化钨粉作骨架,采用无压浸渍工艺,以铜合金作钎焊料,将铸造碳化钨与基体牢固结合,强度、耐磨性大大提高。 |
- Similar Words:
- "铸造树脂" English translation, "铸造双金属" English translation, "铸造速度" English translation, "铸造损耗" English translation, "铸造缩尺" English translation, "铸造碳化钨粉" English translation, "铸造碳化物" English translation, "铸造碳素钢" English translation, "铸造陶瓷" English translation, "铸造特性" English translation
|
|
|