| 1. | This u has two legs , for a total surface area of 75 square inches
型硅碳棒有两段，总辐射面积则为75平方英寸。 |
| 2. | The w or y , with three legs , have a total surface area of 113 square inches
型或者是y型，有三段，则辐射面积为113平方英寸。 |
| 3. | The radiating surface area is calculated by multiplying the diameter by the hot zone length by pi ( 3 . 14 )
计算辐射面积是用直径乘发热部的长度乘3 . 14 。 |
| 4. | The radiating surface area is calculated by multiplying the diameter times the hot zone length times pi ( 3 . 14 )
计算辐射面积是用直径乘发热部的长度乘3 . 14 。 |
| 5. | Read the loading in watts per square unit of radiating surface that can be applied to the element
知道了能应用到硅碳棒的每平方单元辐射面积所能负荷的能量。 |
| 6. | When calculating the wattage capabilities of a element , the unit of watts output per unit of radiating surface area is used
当计算其能量时，要用到每单元辐射面积的输出功率。 |
| 7. | When calculating the wattage capabilities of an element , the unit of watts output per unit of radiating surface area is used
当计算其能量时，要用到每单元辐射面积的输出功率。 |
| 8. | To find the total amount of power one element could supply under these conditions , multiply this value by the radiating surface of the element
在这些条件下，得知一根这种硅碳棒所能提供的总的功率，需乘以其辐射面积。 |
| 9. | Figure 1 shows the recommended watt loading for a square inch or square centimeter of radiating surface as a function of furnace temperature
图1中指出了每平方英寸或者是每平方厘米辐射面积所能负荷的理想能量和熔炉温度的函数关系。 |
| 10. | Generally speaking , the increase of the slot length and width can make the resonance frequency low , which is not the longer the better , however
一般来说,缝隙长、宽的增加可使谐振频率点降低,而较大的缝宽也降低了贴片的有效辐射面积,使增益降低,所以需要折衷协调。 |
