| 1. | Steel roller type conveyor chains , attachments , and sprocket teeth
钢辊型传送链附件和链轮齿 |
| 2. | Experiment study on work roll contour for decreasing silicon strip crown
降低硅钢凸度的工作辊辊型实验研究 |
| 3. | Influence of snapping roll type and harvesting speed on 4yw - q corn harvester
辊型和作业速度对玉米收获机摘穗性能的影响 |
| 4. | The study on on - line ultrasonic roller shape detection based on dual threshold method
基于双阈值法的超声辊型在线检测的研究 |
| 5. | Influence of process factors on roll crown during aluminum strip rolling process
工艺因素对铝带材轧制过程中辊型的影响及控制 |
| 6. | Analytic solution of roll shape curve of bar straightening roll by conjugate surface theory
共轭旋转曲面法求解线棒材矫直辊型曲线 |
| 7. | The perfect camber design can be obtained by introducing the center / side ratio concept of contact pressure and choosing proper ratio
同时引入辊间接触压力的中、边部比值概念并作合理选择，使设计出的辊型更加完善。 |
| 8. | The practical application indicates that the new design not only reduces the convexity of the roll profile obviously , but also leads to homogeneous attrition of rolls and low roll wear
生产实际应用表明，新设计的辊型不仅明显降低了板凸度，同时使轧辊磨损均匀，辊耗量大大下降。 |
| 9. | The rolls wear characteristics and work roll wear pattern were analyzed theoretically and the quantitative analysis were made in shape control and effect factor in accordance with the rolling conditions
从理论上分析了辊系在轧制中的磨损特性，工作辊磨损辊型的计算方法，根据实际轧制工况对其板形的调控、影响因素进行了定量分析。 |
| 10. | In order to make the camber design easier and keep contact pressure equal along rolls , we shall assume the pressure distribution to be quadratic along the width and the marginal deformation to be planar
摘要为了使中厚板轧机辊型设计快捷且保持辊间各点接触压力相等，利用了压力沿板宽方向呈二次分布、板边缘处变形为平面变形的计算处理，从而使辊型设计更为方便。 |
