| 1. | Cfm cathode - follower mixer
阴极跟随器混频器 |
| 2. | Research and design of fuzzy - follower for double - motor driving belt conveying system
双电机驱动胶带运输系统模糊跟随器的研究与设计 |
| 3. | The paper analyzes the fundamental part circuit of current conveyor , the current mirror and the voltage follower
本文分析了电流传送器的基本镜像电流源和电压跟随器模块电路。 |
| 4. | In such cases , the unused amplifier should be connected as a unity - gain follower ( force and sense pins tied together ) and the input should be connected to ground
同样的原因，不用的放大器应当成单位增益跟随器（驱动端和感测端接到一起） ，且其输入端应接地。 |
| 5. | On the other hand , we had obtained the necessary and sufficient condition for the existence of robust decentralized follower when the external unstable model of every subsystem was different with each other
另外，文中还研究了各子系统外作用形式不同时鲁棒跟随器存在的充要条件。 |
| 6. | The states of the system and their differential signals are obtained on time by tracking differentiator , and the influence induced by nonlinear periodic load disturbance is compensated adaptively
电力系统混沌振荡状态和它的微分信号由微分跟随器实时提取，并通过微分跟随器对非线性周期性负荷扰动的影响进行自适应补偿。 |
| 7. | The robust decentralized following control on the basis of the principle of inner model , the necessary and sufficient condition for the existence of robust decentralized follower was extended to general proper systems
分散鲁棒跟随器控制在内模原理的基础上，将文献中有关分散鲁棒跟随器存在的充要条件推广至一般真有理系统。 |
| 8. | When the sensors and actuators of the structure were collocated , we analyzed its stabilizability and gave a decentralized pd stabilizing controller ; we analyzed its follow ability to step input and give a decentralized p1d controller
对于传感器和执行机构同等配置的挠性空间结构，应用得到的有关分散极点配置的结论研究了其分散pd控制器镇定问题；应用关于分散鲁棒跟随器的结论研究了其分散pid控制问题。 |
| 9. | After introduction of the tranlinear loop principal , the bjt current controlled conveyor has been designed by using mixed tranlinear loop voltage follower . as for modern integrated circuit , the model of mos transistor , the active resistance and the current mirror integrated circuit formed by mos transistor are introduced . the cmos current controlled conveyor has been derived from mixed tranlinear loop cmos voltage follower based on weak inversion operation
针对现代集成电路的工艺,本文对mos晶体管的工作原理进行了简要的叙述,讨论了有源电阻和电流镜的实现方法,并利用mos晶体管的亚阈值特性组成混合跨导线性回路完成对应的电压跟随器的设计,推导出了基于cmos技术的电流控制传送器。 |
| 10. | A complementary input stage , which consists of a p - channel pair and a n - channel pair , was used in the circuit , so that the common mode input range can extend from rail to rail . a dcls is used to shift the n - transistor curve leftward to overlap the p - transistor curve properly and keep constant transconductance in the whole common mode input range
输入级采用pmos差分输入对和nmos输入差分对并联的结构，从而实现共模输入范围扩大到电源的正负两端，并且通过两个源级跟随器平移nmos输入管跨导曲线，使nmos输入管和pmos输入管跨导曲线的适当交叠，从而保持了这个输入级的跨导在整个共模输入范围内保持恒定。 |
