English translation for "烧成温度"
|
- burnt temperature
firing temperature
Related Translations:
烧成: bakingburning of brickcalcinationfire 一次烧成: monofiredonce-firingone-step firing processsingle firing
- Example Sentences:
| 1. | The experiment showed that the temperatures and the fiber proportions influenced great on the compressive strength , bending strength , volume density and the porosity of the composites
实验结果表明，烧成温度和纤维含量对复合材料的耐压强度、抗折强度、体积密度和气孔率影响较大。 | | 2. | Mechanical properties were tested and the influence of particle size , sintering temperature , and fiber content on property of the material was studied by the means of x - ray diffraction , om and sem
测试了试样的物理性能和力学性能，通过x衍射、 om及sem ，讨论了纤维含量、烧成温度、原料粒度对材料性能的影响。 | | 3. | In this paper , sral2o4 : eu2 + , dy3 + phosphor with good photoluminescence properties was synthesized successfully through sol - gel method . be compared with conventional solid state method , the reaction temperature can be greatly decreased
该方法较传统的固相反应法明显、有效的降低了反应烧成温度，且产品具有粒径小而均匀的优点。 | | 4. | When sufficient wollastonite is added to ceramic material , the baking temperature can be decreased ang the baking duation greatly shortened to one rapid low temperature bake , thus saving fuel and reduing production costs
在陶瓷原料中加入适量的硅灰石，可以大幅度降低烧成温度，缩短烧成时间，实现低温快速一次烧成，大量的节约燃料，明显降低产品成本。 | | 5. | After the sample is turned out , its internal and external structures are observed and its bulk density is measured in order to determine how the sintering temperature , the time of thermal preservation , and the quantity of admixture affect the performance of lytag
通过对试样内、外部结构观察和容重的测定，研究烧成温度、保温时间及外加剂掺量对粉煤灰陶粒性能的影响。 | | 6. | The range of firing temperature of ceramic tube after dipping changed from 450 c to 1000 c . the above four slurries were also respectively favorable combination with al2o3 ceramic tube , and the range of firing temperature of ceramic tube after dipping slurry varied from 1 000 c to 1400 c
镀膜的陶瓷管烧成温度范围为450 1000 。前述的四种料浆也能良好地与al _ 2o _ 3陶瓷管结合，涂覆料浆的al _ 2o _ 3陶瓷管烧成温度为1000 1400 。 | | 7. | The parameters of impregnation are as follows : ph is about 3 , the range of temperature is from 20 to 45 , and the time is about 2 to 6 hours . after the necessary treatments , zirconia cloths had the optimal strength when the diameters of zirconia fibers were controlled in 4um to 7um , and the sizes of zirconia grains were in 50nm to 100nm . the affec - ting factors were discussed and the liner regression analysis of the cloths was made , from w hich they show that the diameters and grain sizes have the significant influences on zirconia cloths . the obtained zirconia cloths have been accepted for use in nickel - hydrogen batteries by practical use
研究结果表明：粘胶类纤维布最适合制备氧化锆纤维布的前躯体；锆液浓度以饱和溶液为宜；浸渍工艺参数为ph值3左右，温度20 45 ，时间2 6小时；多余锆盐的去除、浸锆液后纤维布的整平处理及平烧施应力烧成有利于氧化锆纤维布的柔软及平整; 200 600烧成温度段应缓慢烧成，控制氧化锆纤维直径在4 7 m ，氧化锆晶粒尺寸50 100nm时氧化锆纤维布的强度最好。 | | 8. | Results show that : ( 1 ) for each particle size of andalusite , variation tendency of the properties of the material is generally the same : the maximum of bulk density , compressive strength and rupture strength appears in the range of 5 % - 10 % content of fiber , these properties of the material remarkably decrease as the fiber content exceed 10 % ; while at the same fiber content , the properties of the material increase with the increase of firing temperature
结果表明： ( 1 )对于不同粒度的原料，性能变化规律大致相同：在同一烧成温度下，体积密度、常温耐压强度、常温抗折强度在5 10之间出现峰值，加入量超过10之后材料的性能明显下降；在相同的纤维含量下，随着烧成温度的提高，试样的各项性能均有所上升。 | | 9. | It was found that there was a close relationship between the adhesion strength of the bg coating and the surface roughness of the titanium alloy and the firing temperature . the chemical state of the elements ti and si at the coating interface varied . the chemical bond and the mechanical occluding make the bg coating form a strong adhesion with the titanium alloy
通过研究发现， bg涂层与基体的结合强度与基体表面的粗糙度以及烧成温度密切相关，涂层界面处ti元素和si元素的化学状态发生了变化， bg与基体强结合的机制为化学键和机械嵌合两种力共同作用。 | | 10. | But the grain growth , grain semiconduction and grain boundary insulation were influenced by many factors , such as the type and contents of dopants , sintering temperature and so on . therefore , in this thesis the effect of the restore sintering temperature , the oxygenize temperature , the donor and acceptor dopant on the dielectric and varistor properties of devices were studied . with sem , the microstructure of srtio3 - based double function ceramic was analyzed
而晶粒生长、晶粒半导化和晶界绝缘化受到多种因素的影响，诸如杂质的种类和含量、烧成温度等，因此本论文研究了还原烧成温度、中温氧化温度、施主和受主掺杂等对srtio _ 3基陶瓷的压敏和介电性能的影响，并借助于sem分析对srtio _ 3基双功能陶瓷的微观结构进行了分析。 |
- Similar Words：
- "烧成炭" English translation, "烧成炭的" English translation, "烧成陶瓷涂料" English translation, "烧成陶瓷涂料 烧结陶瓷涂料" English translation, "烧成陶瓷涂料；烧结陶瓷涂料" English translation, "烧成效果" English translation, "烧成效率" English translation, "烧成性" English translation, "烧成颜色" English translation, "烧成样品" English translation
|
|
|
