| 1. | Laser diode is the most efficient pumping source for solid - state - lasers
激光二极管是固体激光器最有效的泵浦源。 |
| 2. | There is the need for high duty - cycle laser diode array to satisfy the demand the dpssl ( diode pumping solid state laser ) technology
要满足当前的泵浦要求，高占空比大功率激光器阵列是必需的泵浦源。 |
| 3. | Because high power ld is low cost , easy to manipulate and has high power output , it becomes the best option for pumping source of fiber laser
带尾纤输出的大功率半导体激光器具有成本低、易操作、输出功率大等优点成为光纤激光器泵浦源的首选。 |
| 4. | In the fourth chapter , the coupling system between the fiber - coupled - output high power semiconductor laser acting as the pumping source and laser crystal is studied
第四章研究了作为泵浦源的光纤耦合输出大功率半导体激光器与激光晶体间的耦合系统。 |
| 5. | The multiple pump sources are used to increase the output power of single fiber laser , and the two dimensions arrange of fiber laser array increases the number of combining fibers
利用多泵浦源提高单根光纤激光器的输出功率，利用二维光纤激光阵列排列增加参与组束的光纤数目。 |
| 6. | By comparing to that of bbo , we can see that the threshold of clbo is lower than that of bbo . thus clbo provided another excellent crystal in dro if the pump power is low
从结果可以看出，在平面波双谐振下， clbo晶体的振荡阈值低于同等条件下的bbo晶体，从而为连续波、长脉冲等能量较小的泵浦源提供了更加优良的可选晶体。 |
| 7. | We also performed a nonlinear curve fitting to the intensity relation curve between pumped light and upconversion emission light , and knew that the upconversion luminescence belonged to three - photon absorption
通过对上转换发光强度与泵浦源电流强度关系曲线的拟合，看到这种上转换是三光子吸收过程，这与通过能级图分析得到的结果相同。 |
| 8. | The research of er3 + / yb3 + co - doped fiber laser and amplifier is carrying in experiment . the er3 + / yb + co - doped double cladding fiber is produced by ino , the pumping resource wavelength is 977nm , the maximum pumping power coupling into inner cladding is 1 . 33w
公司拉制的e尸+ / yb3 +共掺双包层光纤，泵浦源的波长为977nm ，最大输出功率为2 . 46w ，实际祸合到双包层光纤中的最大功率为1 |
| 9. | Both of the numeric simulations and the experimentations indicate that the c band raman fiber amplifier can be satisfied with some gain flatness when numbers and wavelengths of pump are installed while powers of pump are arranged properly . the method of measuring fiber raman gain coefficient is adopted to other type
数值计算和试验上都证明了在合理地选取泵浦源的个数和波长的情况下，通过对各个泵浦功率配置的调整， c波段的拉曼光纤放大器可以满足一定的增益平坦度。 |
| 10. | A ld pumped lbo / bbo / nd : yag 266nm all - solid - state ultraviolet laser and purple and a ld pumped ktp / bbo / nd : yag 266 nm all - solid - state ultraviolet laser were designed respectively ; 1 . 5mw and 2 . 0mw average output power were obtained respectively when maximum input power of ld was 1 . 3 w . reasons of being elliptical beam and 45 ? rotation for the beam were also explained
设计出一台lbo bbo nd ： yag266nm全固态紫外激光器和一台ktp bbo nd ： yag266nm全固态紫外激光器；用1w的ld作为泵浦源，在最大抽运功率为1 . 3w时，分别获得了平均功率为1 . 5mw和2 . 0mw的266nm紫外输出。 |
