| 1. | According to the best selected parameters , it gave the system frequency speciality and dynamic performance
根据所选最佳参数进行仿真，给出系统的频率特性及动态性能指标。 |
| 2. | Although the system has not been optimized to maximize the raman spectra , it is shown spectra can be obtained rapidly
虽原此系统并未针对拉曼光谱强化找出最佳参数，但结果显示其光谱显示相当快速。 |
| 3. | For optimizing the power supply circuit , and receiving optimization of parameter , the power supply circuit has been simulated by pspice software
同时，为了优化电源电路，获取电路最佳参数，用pspice软件对电源电路进行了计算机仿真。 |
| 4. | The objecti ve function with the aim at the least power consumption was set up and genetic a lgorithms ( ga ) was applied to optimize the objective function
并以功耗最小为目标，运用遗传算法对所建模型的参数进行了优化，确定了最佳参数组合。 |
| 5. | The analysis of variance for the grey relational grade was implemented , and the optimum value of multi - objectives was obtained , so that the optimum combination of the factors was confirmed
对目标序列的灰色关联度进行方差分析，得到目标函数的最优解，从而获得最佳参数。 |
| 6. | You may create several mining models using the same algorithm , but with a parameter set differently for each mining model to find the best setting for the parameter
可以使用相同的算法创建多个挖掘模型，但通过将每一个挖掘模型中的一个参数设置为不同的值来查找最佳参数设置。 |
| 7. | 2 . the long - addendum coefficient of pump gear must make the gear in the condition of undercut . base on these conclusions , the basic parameters of pump gear are optimum
本文提供了完整的泵齿轮最佳参数的计算公式，计算方法既能使泵齿轮参数达到最佳，而且计算简单，工艺性也较好。 |
| 8. | The effects of the beam parameters on the focusing are also discussed , and it is found that some of the parameters have optimum values which result in the strongest focusing of the probe beam
进一步分析了光束初始参数对信号光聚焦过程的影响，发现选择最佳参数值可提高光束的聚焦效率。 |
| 9. | Finally , the parameters were optimized by using programming method and the optimum combination of the parameters was determined and the verifying test proved the validity of the results
利用计算机规划求解分析方法，对模型进行优化计算，得出秧苗埋苗率最小时的最佳参数组合，并进行了试验验证。 |
| 10. | The paper derives a new calculation formula for contact ratio of pump gear , provides a c language program as well , which make the pump gear optimum design convieniently
为了方便测绘计算，输出的结果是满足齿轮泵性能要求的，并按泵齿轮中心距排列的多组泵齿轮最佳参数，供设计者根据现场要求选择使用。 |
