| 1. | The limit of the thickness of the join on a mitered corner
斜接角上联接宽度的限制。 |
| 2. | The miter length can be large when the angle between two lines is small
当两条直线之间的角度很小时，斜接长度可能很大。 |
| 3. | Mitre block mitre joint
斜接斜面接合块 |
| 4. | Gets or sets the limit of the thickness of the join on a mitered corner
Pen . miterlimit属性获取或设置斜接角上联接宽度的限制。 |
| 5. | Taper pressure ring
斜接压力环 |
| 6. | The miter limit is the maximum allowed ratio of miter length to stroke width
斜接限制是指斜接长度与笔划宽度之间的所允许的最大比值。 |
| 7. | The miter length is the distance from the intersection of the line walls on the inside of the join to the intersection of the line walls outside of the join
斜接长度是指线壁在联接内部的交点与线壁在联接外部的交点之间的距离。 |
| 8. | If the miter length of the join of the intersection exceeds the limit of the join , then the join will be beveled to keep it within the limit of the join of the intersection
如果交点的斜接联接长度超过联接限制，则联接将被倾斜以便落在交点的联接限制范围内。 |
| 9. | The approximate formula is : the initial bounding rectangle is inflated by pen width , and this result is multiplied by the miter limit , plus some additional margin to allow for end caps
近似公式为：初始边框按钢笔宽度扩充，结果乘以斜接限制，再加上用以容纳端帽的一些附加边距。 |
| 10. | The size of the returned bounding rectangle is influenced by the type of end caps , pen width , and pen miter limit , and therefore produces a " loose fit " to the bounded path
所返回边框的大小受端帽类型、钢笔宽度和钢笔斜接限制的影响，因此产生一个“松散适合”于被限定路径的矩形。 |
