| 1. | Design and application of dc ac differential signal source converter
差分信号源变换电路的设计与应用 |
| 2. | Discussion of the control method of circuit topology of zct - pwm converter
功率变换电路控制方式的讨论 |
| 3. | Frequency - conversion circuit
频率变换电路 |
| 4. | The traditional power amplifier circuits ( most of them have ocl structure ) are low - efficient and bulky ones
目前，高保真度的功率变换电路多采用甲乙类ocl功放电路，这类电源效率低、体积重。 |
| 5. | The task of the test system is to comprehensively test the electrical performance parameters of the pulse convert circuit which is one of the accelerometer components in the system products
测试系统的任务是综合测试导弹捷联惯导系统产品中加速度计组件之一“大量程脉冲变换电路扳”的电性能参数。 |
| 6. | In the paper , a high power switch supply is developed using phase - shifted full - bridge zvs pwm dc / dc converter circuit and the current - sharing circuit is designed for parallel operation of multi - module
论文采用移相全桥zvspwmdc dc变换电路研制了大功率开关电源，并设计出多个电源模块并联运行时的均流电路。 |
| 7. | The improvement can also be used to correct total differencial and integral errors caused by pre - amplifier , linear amplifier , shaping circuit , peak stretcher and holder as well as adc at the same time
这种方法也可校正由前置放大器、线性放大器、成形电路、峰展宽电路和模数变换电路等共同造成的微分非线性和积分非线性。 |
| 8. | This paper analyzes the unitary structure and work principle of the power source and explains the work principle of scr pre - regulate circuit , serial voltage regulate circuit and high frequency switch circuit
文章中分析了电源的整体结构和工作原理，并详细的讲述了预稳压电路、线性串联稳压电路、功率推挽变换电路等电路的工作原理。 |
| 9. | In addition , the paper also designed the driving circuit for communication , the signal tuning and a / d convertion circuit for signal collection , and d / a convertion and the v / i transform circuit for output
此外,本文还设计了用于通讯接口的隔离驱动电路、用于数据采集的信号调理电路和a / d转换电路以及用于控制量输出的d / a转换电路和v / i变换电路等硬件电路。 |
| 10. | Dc / dc transfer , high efficient and less noise , meet the different voltage and current need by each module . the mts use isolated dc / dc module to provide power for dilapidation detectors , avoiding lightning strike
Dc dc转换采用了高效率、低噪声的dc dc变换电路满足各模块的电压和电流需要；终端采用了隔离dc dc模块为崩塌传感器提供电源，防止雷击对终端其它模块的影响。 |
