| 1. | Exchange - compression stroke
换气压缩行程 |
| 2. | It was found that the compression speed and compression stroke are the two factors affecting the molding pressure most significantly
由模拟找出了压缩速度与压缩行程是两个影响成型压力极大的因素。 |
| 3. | It was found that the compression speed and compression stroke are the two factors affecting the molding pressure most significantly
由仿真找出了压缩速度与压缩行程是两个影响成型压力极大的因素。 |
| 4. | Using lower switch time , lower compression speed and higher compression stroke will result in lower cavity pressures
使用较短的切换时间、较低的压缩速度以及较高的压缩行程将产生较低的模安穴压力。 |
| 5. | When the engine runs in compression stroke and power stroke , the valves must close tightly on their seats to produce a gas - tight seal and thus prevent the gases escaping from the combustion chamber
当发动机处于压缩行程和做功行程时，阀门必须紧紧地关闭以产生一个不透气的气封，以防止气体逃离燃烧室。 |
| 6. | The controller of magnetorheological semi - active suspension system was consisted of drive current control subsystem of magnetorheological damper and mechanical structural fuzzy control subsystem of vehicle , the unsymmetry damping force relation of suspension compress travel and promote travel is solved with coefficient of language - value of damper force output variable
由汽车结构振动模糊控制子系统和磁流变阻尼器驱动电流控制子系统构建了磁流变半主动悬架控制器，用模糊集语言赋值系数反映了悬架伸张行程和压缩行程不对称阻尼控制力的关系。 |
| 7. | Simulation and the associated numerical algorithm on the injection - compression molding ( icm ) process were developed to understand processing characteristics by changing processing parameters including compression speed , switch time from injection to compression , compression stroke as well as initial cavity thickness and part thickness using disk parts
摘要射出压缩成型的仿真以及数值运算是要了解成型参数的改变，包括：压缩速度、射出与封装的切换时间、压缩行程等制程特性而创建的，同时也包含了初始的开模厚度以及使用在光盘片的成品厚度。 |
| 8. | Simulation and the associated numerical algorithm on the injection - compression molding ( icm ) process were developed to understand processing characteristics by changing processing parameters including compression speed , switch time from injection to compression , compression stroke as well as initial cavity thickness and part thickness using disk parts
摘要射出压缩成型的模拟以及数值运算是要了解成型参数的改变，包括：压缩速度、射出与压缩的切换时间、压缩行程等制程特性而建立的，同时也包含了初始的开模厚度以及使用在光碟片的成品厚度。 |
