| 1. | Effect of temperature of coagulation bath on structure and properties of lyocell fibers from bamboo pulp
凝固浴温度对有机溶剂法再生竹纤维素纤维结构与性能的影响 |
| 2. | Effects of coagulation bath temperature on the structure and performance of polyethersulfone hollow - fiber membranes by dry wet process
凝固浴温度对相转化聚醚砜中空纤维膜结构与性能的影响 |
| 3. | If coagulant bath temperature was too high , flat membranes would have presented themselves with all kinds of defects
凝固浴温度对填充聚合物平板膜有很大影响。温度过高时，所得平板膜易出现多种缺陷。 |
| 4. | 4 . the effect of the temperature and concentration of the second coagulation bath on the structure and properties of pes membranes are studied
4 .研究了第二凝固浴温度和浓度对聚醚矾膜的结构与性能的影响。 |
| 5. | The studies on stability of pu - sio2 , pes - sio2 suspensions and influence coagulant bath temperature on flat membrane were carried out
研究了无机粒子填充聚合物悬浮铸膜液的稳定性及凝固浴温度对平板膜成形的影响。 |
| 6. | The membranes exhibit good hydrophilic performance and high water flux with highly loose and inter - connective microstructure , which is potential for the separation of protein
优化了制膜工艺条件，并对影响膜结构与性能的一些因素，如聚合物浓度、添加剂含量、铸膜液温度和凝固浴温度进行了研究。 |
| 7. | As the temperature of the second coagulation bath increases , the water flux increases and the clearance rates of urea and creatintine first increase then decrease and increase a little at last
随着第二凝固浴温度的上升，水通量一直上升，肌肝和尿素的去除率先是上升，然后下降，最后又有略微上升的趋势。 |
| 8. | The results showed that when the nmmo concentration of coagulation bath is 20 % , the temperature is 25 and the cotton pulp concentration is 5 % , cellulose packaging films with the excellent mechanical properties can be prepared
结果表明，棉浆浓度为5 % ，凝固浴浓度为20 % ，凝固浴温度为25时，可制得有较好力学性能的纤维素包装膜。 |
| 9. | With an increase of nmmo concentration of coagulation bath or concentration of casting solution , the crystallinity of membrane increases . however , an increase of temperature of coagulation bath is accompanied by a decrease of crystallinity of membrane
膜的结晶度随铸膜液浓度、凝固浴浓度、刮膜速度的增加而增大，随凝固浴温度的升高而降低。 |
| 10. | 5 have a better recovery . the flux - transmembrane pressure curves of several kinds of pu composite hollow fiber membranes differed completely from non - deformation membranes , deviated from the linear relation obviously . this strongly indicated that , due to pu characteristics , such as good elasticity and strong recovery , pu - sio2 composite hollow fiber membranes have a comparatively good pressure - responsivity
通过调整纺丝液浓度、 sio _ 2含量、中空芯液流量、纺丝温度、凝固浴温度等参数，纺制出5种较为理想的压力响应性pu复合中空纤维膜，其中，含有20和25 sio _ 2的pu复合中空纤维膜孔径增加和孔径回复最为理想。 |
