| 1. | A partition boot record is usually referred to as the partition root superblock
通常将分区引导记录称为分区引导超级块。 |
| 2. | The most common limitation is the offset allowed to the start of the partition superblock
最常见的限制是到分区超级块的开始处所允许的偏移。 |
| 3. | Instead of placing lilo in the new linux logical partition superblock , it is placed in the master boot record
用户没有将lilo放在新的linux逻辑分区超级块中，而是放在主引导记录中。 |
| 4. | An aggregate is an array of disk blocks containing a specific format that includes a superblock and an allocation map
聚集是包含一种特定格式的磁盘块阵列，其格式包括超级块和分配映射表。 |
| 5. | The superblock identifies the partition as a jfs aggregate , while the allocation map describes the allocation state of each data block within the aggregate
超级块将分区标识成jfs聚集，而分配映射表描述聚集内每个数据块的分配状态。 |
| 6. | Together , the aggregate superblock and disk allocation map , file descriptor and inode map , inodes , directories , and addressing structures represent jfs control structures or meta - data
聚集超级块和磁盘分配映射表、文件描述符和inode映射表、 inode 、目录以及寻址结构一起表示了jfs控制结构或元数据。 |
| 7. | Partition requirements of some operating systems operating boots from root partition approx . has to be system primary or superblock format space on first logical drive boundary needed drive
操作从主驱动器引导引导分区大致是否需要系统还是从逻辑驱动超级块格式需要的位于第一器引导边界空间驱动器上 |
| 8. | The program is installed in the mbr of the primary hard drive , replacing the os boot program that would simply select the active partition and load the os boot program from the root superblock
该程序被安装在主硬盘驱动器的mbr中，来替换只是简单选择活动分区并从根超级块装入os引导程序的os引导程序。 |
| 9. | Then you set the " persistent - superblock " to 1 , telling the raid tools that when this volume is created , a special superblock should be written to each constituent device describing the configuration of the raid array
然后将" persistent - superblock "设置为1 ，告诉raid工具何时创建该卷，应该为每个组成设备编写特定的超级块，以描述raid阵列的配置。 |
