Chinese translation for "惯性负载"
|
- inertia load
Related Translations:
惯性阻力: inertia resistanceinertial resistance 惯性常数: co tant of inertiaconstant of inertiainertia constant 惯性导引: guidance; inertialinertial navigation system
- Example Sentences:
| 1. | The key problem of design of inertia brake test rigs is the simulation of inertia load
惯性制动器试验台设计的关键问题是惯性负载的模拟。 | | 2. | One pump powered by gas engine and multi - actuators is a popular model in construction machine field . the performance of construction machines suffers from their large inertia loads and multi - actuators seriously
工程机械本身一般有大小惯性执行器并存，工程机械的这种大惯性负载及多执行器系统对工程机械的操纵性能产生较大影响。 | | 3. | This work is useful to the design and analysis of the new ejection mechanism , especially the new cylinder . finally , we gave some clue for further research basing on the summary of this paper
最后分别分析了不同惯性负载mw 、不同行程s 、不同有效面积ae对作动筒动特性的影响，为设计新的导弹弹射装置特别是气压作动筒提供了理论依据。 | | 4. | This paper is focused on the mathematical description of hydraulic control system , in which the hydraulic power comes from variable pump , the actuators are two valve - controlled motors , and the load is purely inertial
摘要探讨了由变数泵为液压源、 2个阀控马达为执行元件以及惯性负载组成的液压控制系统的数学描述，并给出了其线性化模型。 | | 5. | From the starting of running and braking property of inertia load in this article , the method of simulation of inertia load is analyzed , including the simulation of reducer and flywheel , and the electronic simulation idea is brought forward in allusion to the problem of those methods
本文从惯性负载的运行及制动特性入手,分析了模拟惯性负载的方法,包括用减速机、飞轮来模拟,针对这些方法存在的问题提出了电模拟法的思想。 | | 6. | It brings about the problems of low flow - used ratio and bad harmony in flow dividing control when simultaneously operating multi - actuators with different inertia loads . this paper is aimed to solve these problems by method based on pressure decrease sensing and meter - in flow rate feedback control of actuators . in this paper , several important points including theoretical analysis , computer simulation , and experiment study will be explained
本论文主要针对因执行器所驱动惯性负载的差异而引起流量利用率低和协调性不佳的问题，提出了一种基于压差传感和执行器进油侧流量反馈的分流控制方法，并进行了相应的理论分析、仿真研究和实验研究。 | | 7. | Then pid flow rate control algorithm is introduced . all experiments made in this chapter are about measuring the valve parameters according to spool positions , single actuator flow rate control by the calculated flow rate feedback control method , free flow rate dividing control under the sufficient pump discharge flow rate situation , proportion flow rate dividing and flow rate dividing based on meter - in flow rate feedback control method under insufficient pump discharge flow rate situation . the results of all experiments proved that the method presented in this thesis is an effective way to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads
第四章介绍了多执行器复合控制实验系统和实验方法；介绍了实验采用的流量控制的pid算法；并测定了执行器控制阀和阀芯位移相关的系数；做了单个执行器计算流量反馈流量控制、流量足够情况下多执行器流量任意分配、流量不足情况下多执行器按比例调节流量分配和多执行器进油侧流量反馈分流控制实验；通过实验说明了论文提出的分流控制方法能实现大小惯性负载复合操作时的合理分流。 | | 8. | The core control of the whole control system is accomplished by plc , including sequence action control , numerical calculation , processing control of frequency and so on , and the realization of vvvf is accomplished by transducer . the simulation of inertia load is completed well by union of both plc and transducer
整个控制系统的核心控制由plc完成,包括动作顺序控制、数值计算、频率的过程控制等,而变频调速的实现靠变频器来完成的,两者相互结合较好地完成了惯性负载的模拟。 |
- Similar Words：
- "惯性分离器" Chinese translation, "惯性风分器" Chinese translation, "惯性风力分级机" Chinese translation, "惯性俯仰力矩" Chinese translation, "惯性赋能器" Chinese translation, "惯性杆" Chinese translation, "惯性跟踪" Chinese translation, "惯性工作状态" Chinese translation, "惯性骨导" Chinese translation, "惯性轨道" Chinese translation
|
|
|
