Chinese translation for "复压"
|
- re-pressing
- Example Sentences:
| 1. | Pressure compounded turbine 复压涡轮机 | | 2. | The composite was pressed and sintered again to further enhance its synthetical properties . through this treatment , interface binding strength , compactness , conductivity and mechanical properties of the composite were prominently increased 复压复烧处理后,铜基体与碳纤维之间结合状态良好,复合材料的致密度、电导率及机械性能均有显著提高。 | | 3. | On this basis , we study the content of carbon nanotube influence to mechanical and electrical properties , we find composite materials can get high relative density after press ; at the volume content of carbon nanotube low 11 % , carbon nanotube may act as enhancement s to hardness , composite hold better electrical conductivity . after high 11 % , relative density quick decrease and resistance quick increase , for carbon nanotube do not complete disperse 结果表明:在复压后复合材料可以达到比较致密的程度;在碳纳米管体积含量小于11时,碳纳米管可以提高复合材料硬度,且复合材料的电导率较高:碳纳米管体积含量大于11以后,因为碳纳米管发生团聚,导致相对密度下降、电阻率上升。 | | 4. | Preparation for construction : the surface of the under layer should be even and firm , and in accordance with the design requirement , without loose material and flaccid site , and need to reroll 2 3 times within full - width range of the subgrade with vibrating roller before the construction , as well as test the compaction and defecting , to check whether there is unqualified point in the soil base 施工准备:施工前下承层表面要平整、坚实,符合设计要求,无松散材料和软弱地点,施工前要用振动压路机在路基全宽范围内复压2 3遍,同时进行压实度及弯沉检验,检查土基中是否有不合格点。 | | 5. | In this paper , systemic experiments are performed on the compositions , processes , microstructures and properties of some high quality pm inserts . main procedures such as mixing , compaction , sintering , re - compaction , re - sintering , heat - treatment , properties detection and mould design and so on are included in these experiments 本文对几种高性能粉末冶金摇臂镶块的成分、工艺、组织和性能等进行了系统的实验研究,包括混粉、初压、初烧、复压、复烧、后续热处理、性能检测、现场模具设计等。 |
- Similar Words:
- "复熏检查,校验" Chinese translation, "复循环河" Chinese translation, "复循环机组" Chinese translation, "复询信" Chinese translation, "复训" Chinese translation, "复压级" Chinese translation, "复压片" Chinese translation, "复压缩" Chinese translation, "复压涡轮机" Chinese translation, "复芽" Chinese translation
|
|
|