| 1. | The paper explains the control force with the center of performance index . the static error is an important index of the control system
稳态误差是控制系统一个很重要的性能指标，在九点控制器中k _ 0是稳态时的控制作用。 |
| 2. | Because of high stability , the voltage loop gain is set high , so the static error is very small and dynamic performance is enhanced
由于内环的高度稳定性，所以电压环的增益可做得很高，使系统的静态误差非常小且动态性能得到了提高。 |
| 3. | Its static error is categorized into three types : irrelative with the specific force , relative with the first - order of specific force and relative with the square of specific force
把漂移误差分为与比力无关、与一次方成比例和与二次方成比例三类。 |
| 4. | To ensure the high precision of the on - line measuring system , the static error and the dynamic capability of the whole system must be good enough
要实现高精度在线检测，首先要保证有足够高的静态精度，然后在此基础上，保证其动态特性能满足在线检测的要求。 |
| 5. | The meassure to reduce the static error when manufacturing axial parts on a hydralic profiling tool slide is deduced in theory with positive feedback adjusting method
本文应用顺馈校正的方法，从理论上导出了在车床上用液压仿形刀架加工轴类零件减小稳态误差的措施。 |
| 6. | Then a fuzzy control system is designed on the basis of the characteristic of boiler , though the dynamic quality is improved , there is static error
在此基础上结合锅炉对象的特点设计了水位控制的模糊控制系统，虽然系统动态品质得到明显改善，然而系统存在稳态误差。 |
| 7. | Taking the spherical - wrist of robot ' s end as the target of study , a kind of static error analysis method of spherical - wrist expressed by relative posture errors has been put forward
以机器人末端的球腕为研究对象，提出了一种用相对位姿误差表示球腕的静态误差分析方法。 |
| 8. | After the system is demarcatted , its performance is as follows : the stress resolution is 99pa ; the range of measure is 24kpa ; the static error is less than 2 % ; 4
对实时采集系统进行定标后，发现系统的应力分辨力为99pa ，量程为24kpa ，静态误差小于2 % ，重复性好，稳定性好。 |
| 9. | Abstract : the meassure to reduce the static error when manufacturing axial parts on a hydralic profiling tool slide is deduced in theory with positive feedback adjusting method
文摘:本文应用顺馈校正的方法，从理论上导出了在车床上用液压仿形刀架加工轴类零件减小稳态误差的措施。 |
| 10. | In the fuzzy control method , a pi fuzzy control with nested control table is studied . experimental results show that the static error and the oscillation can be reduced
在模糊控制研究中，提出采用pi型及模糊控制表嵌套控制方法，基本上消除了常规模糊控制存在的静差和振荡现象。 |
