Chinese translation for "额定转速"
|
- no load speed
rated revolution
rated speed of rotation
specified speed
Related Translations:
额定量: capacity ratingmarked capacityrate capacityrated capacityrated flowrated quantityspecified rate 额定速度: nominal rated speednominal speednormal speednormal velocityrated eedstipulated velocityvelocity rating 额定过载量: overload ratingoverlond rating
- Example Sentences:
| 1. | The throttle plate moves toward the closed position as rated speed is reached .
当达到发动机额定转速时，节流板趋于关闭位置。 | | 2. | Is 3000 revolutions per minute , which then generates electricity to complete the energy conversion process .
所采用的涡轮发电机的额定转速为每分钟三千转，从而产生电力及完成整个能源转化过程。 | | 3. | Is 3000 revolutions per minute ) , which then generates electricity to complete the energy conversion process
所采用的涡轮发电机的额定转速为每分钟三千转) ，从而产生电力及完成整个能源转化过程。 | | 4. | Remarks : all chefeng series diesel engines is 1 , 000 rpm in rated speed , except that model 12v180zd diesel engine is 1 , 500 rpm
备注：晨风柴油机除了12v180zd额定转速为1500rpm ，其余晨风柴油机额定转速均为1000rpm 。 | | 5. | This frequency range is proximate to main vibration frequency of the traction machine at rated speed , and , according to this , measures against elevator resonance are proposed
并针对该频率区与曳引机主机额定转速主振频率接近的特点，提出了防止电梯发生系统共振的措施。 | | 6. | Mechanical vibration - evaluation of machine vibration by measurements on non - rotating parts - part 3 : industrial machines with nominal power above 15kw and nominal speeds between 120r min and 15000r min when measured in situ
在非旋转部件上测量和评价机器的机械振动第3部分:额定功率大于15kw额定转速在120r min至15000r min之间的在现场测量的工业机器 | | 7. | By using the hydraulic torque converter to drive the mud pump , both the prime motor and the working machine can be protected , and the pump pressure can be controlled in the whole course of drilling if the rated rotary speed of the diesel engines is kept
通过液力变矩器驱动钻井泵可同时保护原动机和工作机；在保持柴油机额定转速的条件下，可实现泵压的全过程控制。 | | 8. | Studies indicate that : ( 1 ) it is the approach of the first natural frequency of the handle ( 43 . 9hz ) and the working frequency under the rated rotate speed of the engine , due to the unreasonable mechanism design , that causes the serious vibration on the handle of the gn31 cultivator
研究表明： ( 1 ) gn31耕整机扶手架的振动量过大主要是由于扶手架的1阶固有频率( 43 . 9hz )和耕整机发动机的额定转速下的惯性力1阶频率( 43 . 3hz )接近，为扶手架结构设计不合理所致。 | | 9. | Then analytical measurements of the noise were carried out on both of the turbines by means of modern acoustic apparatus and a conclusion has been found that the noise of the concentrated wind energy turbine is lower than the one of the ordinary wind energy turbine and the root of the trouble to cause noise chiefly originates from the turbine blade . besides , the result of analytical measurement also reveals that the power output both of the wind energy turbines will increase with the increase of the wind speed and unfortunately does the noise too . in order to lower the noise , a measures of noise reduction have been advanced that an active method is to develop a wind energy turbine run at a lower rating of wind speed while the passive method is to adopt a board drilled tiny holes , having established a sound technological basis for the development of a kind of wind energy turbine of low noise and high level in the world
主要对浓缩风能型风力发电机在正常运转时，噪声产生的机理进行了理论分析研究，并与普通型风力发电机的噪声进行了对比实验分析；利用现代声学测试手段对两类机型进行测试与分析，得出浓缩风能型风力发电机产生噪声低于普通型风力发电机和叶轮是风力发电机产生噪声的主要部件的结论；通过对两类机型的噪声、输出功率的测试，得出随着风速的增加，两类风力发电机的输出功率在增加，产生的噪声也在增加的结论；提出了进一步降低浓缩风能型风力发电机噪声的措施，从主动降噪方面，研制低额定转速的发电机；从被动降噪方面，采用微孔穿板的降噪结构；为研究开发一种国际上低噪声、高水平的风力发电机打下了良好的技术基础。 | | 10. | It analyses the causes to bright image movement , studies principle to compensate image movement , conforms project to compensate image movement , and designs framework to compensate image movement in the article ; to analyze and design configuration of the scanning mirror , to select matters of mirror and its support structures on the principle of consistent line expansion coefficient ; to ascertain type of moment electromotor by most rotating angle speed and most rotating moment which are required by loads in the period to take pictures , as well as by figuration size of electromotor ; to design retarder according as the electromotor parameters ; to design and optimize lightweighted mirror shapes , because the mirror is key part ; to design flexure support structure , to analyze static and dynamic characteristics of the support structure by name of patran program for validating desig n rationality ; to study function of the scanning mirror electric control system ; to test precision of the system , the results indicate the rationality of design of the scanning mirror system
本文通过分析像移产生原因、研究像移补偿原理，确定像移补偿方案，并根据像移补偿原理设计补偿机构；分析与设计扫描反射镜系统结构，根据材料线膨胀系数一致原则，选择反射镜及其背部支撑的材料；由扫描反射镜在摆扫周期内的最大摆扫角速度确定力矩电机的额定转速，根据负载力矩确定电机的额定转距，综合电机外型尺寸等因素，确定执行元件? ?电机的型号；根据所选电机的参数指标，设计1 ： 6速比的减速器；利用patran软件对扫描反射镜系统中的关键件? ?反射镜进行轻量化设计与优化；设计反射镜柔性支撑结构，并通过软件分析支撑结构的力学特性，验证反射镜柔性支撑结构设计的合理性；从原理上研究扫描反射镜控制系统功能；进行系统精度测试，测试结果表明扫描反射镜系统设计的合理性。 |
- Similar Words：
- "额定转差率" Chinese translation, "额定转舵扭矩" Chinese translation, "额定转矩" Chinese translation, "额定转距" Chinese translation, "额定转数" Chinese translation, "额定转速时的转矩" Chinese translation, "额定转鳍力矩" Chinese translation, "额定装入量" Chinese translation, "额定装载量" Chinese translation, "额定状态" Chinese translation
|
|
|
