Chinese translation for "镀膜厚度"

schichtdicke coating thickness thickness of layer

Related Translations:

成品厚度:  end thickness

漏镀:  skiprinting skiplating

镀焊剂:  soldering plating

干镀:  dry coating

坏镀:  mechanical galvanized

焰镀:  flame plating

镀涂:  overlay

镀铬:  chromate treatment; chrome-plating; chroming; chromium-plating 短语和例子镀铬合金的物体 chrome; 镀铬层 chromium coating; 镀铬物 chrome

涂镀:  brushing platingcoating

光学镀膜:  optical coatingoptical filming

Example Sentences:

	1.	A control system for the thickness of ion beam sputter ( ibs ) coating is introduced in this paper . the basic principle of ibs coating machine is discussed . this paper also gives the scheme of hardware and sofeware 本文介绍了离子束溅射镀膜机膜厚控制的一种实用的系统，文中论述了离子束溅射镀膜机的工作原理及镀膜厚度控制系统的硬、软件的实现方案。
	2.	Prepared technical parameters were optimized by l9 ( 34 ) experiment analysis . a unique method for cleaning and drying of substrate - cleaning used by scour , drying used by infrared light was fished out by large numbers of experiment . chemical mechnism of zno thin film prepared by sol - gel technique was discussed by dta for the first time . by the measurements of sem , xrd and uvs , the thin film was analysed . the result proved that the thin film with strongly preferred orientation of c - axis perpendicular to the substrate surface which surface was homogenous , dense and crackfree was the crystalline phase of hexagonal wurtzite . the thin film was composed of plentiful asteroidal crystal which crystal dimension approximately 10 30nm . the average transmittance of thin film in visible region was above 90 % . the results of measurements else also proved that the thickness of single dip - coating was 75 240nm , this films resistivity was found to be 3 . 105 102 3 . 96 105 ? cm . the thickness and resistivity of thin film influenced by dope - content , withdrawal speed , pre - heat - treatment , anealing were reseached respectively 利用xrd 、 sem以及uvs光谱仪等分析方法对薄膜进行了研究，结果显示，所制备的薄膜为六方纤锌矿型结构，具有高c轴择优取向性；表面均匀、致密，薄膜材料由许多星状晶粒组成，晶粒尺寸大约为10 - 30nm左右；薄膜可见光透过率平均可达90 % ；对薄膜厚度以及电学性能进行了测定后发现：单次镀膜厚度约为75 - 240nm ， al ~ ( 3 + )离子掺杂型氧化锌薄膜的电阻率在3 . 015 102 - 3 . 96 103 ? cm范围内；分别研究了掺杂浓度、提拉速度、预烧温度、退火温度等工艺参数对薄膜厚度和电阻率的影响。

Similar Words：

"镀膜材料" Chinese translation, "镀膜的" Chinese translation, "镀膜盖玻片" Chinese translation, "镀膜光学" Chinese translation, "镀膜光学系统" Chinese translation, "镀膜机" Chinese translation, "镀膜计" Chinese translation, "镀膜加工" Chinese translation, "镀膜列表" Chinese translation, "镀膜滤色镜" Chinese translation