| 1. | That is, the load is dropped off in the proportion to the crack length .
这就是说，载荷随裂纹长度的增加而按比例地下降。 |
| 2. | The smaller the curvature and the larger the crack length the smaller will be the fracture stress .
曲线半径越小，裂纹长度越大，断裂应力也就越低。 |
| 3. | The effect of these nonlinearities can be avoided by determining compliance at the same maximum load for all crack lengths investigated .
这些非线性效应，可在测定所有裂纹长度的柔度方法时，采用最大载荷不变的方法予以消除。 |
| 4. | A special testing fixture and the crack length measurment method for crack fracture and propagation in mixed mode
复合型裂纹断裂和扩展速率试验夹具及裂纹长度测量方法 |
| 5. | Through studying the relation between crack lengths and loading point compliance , we get the quantificational formula
通过探索加载点位移曲线得到柔度与试样裂纹长度的关系，建立定量计算式。 |
| 6. | 5 . 4 or hole length , crackle of edge , quite on 80 mm , hole and hole allow to feed through the crackle in the excellent hole
5 . 4棒孔内或孔边缘裂纹长度不大于80mm ，孔与孔之间不允许有连通裂纹。 |
| 7. | In international , electric potential is used widely . it is expensive to experiment with the method
高温环境下疲劳裂纹长度的测量一直是个难题，国际上常用的测量方法是试验成本较高和电位法。 |
| 8. | The repair effect is compared with various type of repair and effect of residual thermal stress patch width thickness and thickness of adhesive layer
在修补前与修补后，裂纹板的j积分值与裂纹长度的关系发生明显的变化。 |
| 9. | The reliability ' s construe result for the magnitude of stress , and the flaw length and the life of flaw extend will be helpful to the modernization administration for the portal crane
对应力幅、临界裂纹长度及裂纹扩展寿命的可靠性分析所得出的结论对以后的港口机械的现代化管理有一定的理论和实践指导意义。 |
| 10. | The cracking with these two types of underfill might become unstable and lead to catastrophic failure at the end . the critical length was about 12m for the assembly with no - flow underfill and 20m for the package with capillary - flow underfill at 20 ?
模拟表明，山固化温度冷却到室温时，所研究的倒装焊封装在填充不流动胶时芯片断裂临界裂纹长度为12pm ，而填充传统底充胶时为20hm 。 |
