| 1. | Experiment research on radiator used at semiconductor refrigerator
半导体冷藏柜用热端散热器的实验研究 |
| 2. | Experimental study on the length of vortex hot tube effect on the performance of vortex tube
热端管长度对涡流管性能影响的实验研究 |
| 3. | An introduction to the pre - installation preparation for the hot - end equipment of glass production line
浅谈玻璃生产线热端设备安装前期准备 |
| 4. | A experimental study on a cooling system of a small flow vortex tube with the humidifer at the hot end
小流量涡流管热端加湿制冷系统实验研究 |
| 5. | This application covers the case where the hot side is pure steam , condensing isothermally
这主要应用在热端是纯蒸汽，冷却是等温线降温时使用。 |
| 6. | A major application is also in glass coatings where it is used to improve scratch resistance and to decrease the coefficient of friction . it is especially helpful for glass container manufacturers . specification
主要用途：三氯-丁基锡是一种pvc稳定剂的重要中间体，它主要用于玻璃容器表面的热端涂层。 |
| 7. | Streaming from the hot end to the cold end of the regenerator was found which would waste much useful heating energy . modified structure of the jet pump could control this sort of streaming efficiently
实验中还观察到了直流现象，气体从回热器热端向冷端运动，造成大量的能量浪费，通过改进喷射泵结构可以有效抑制直流。 |
| 8. | The calculation result is compared with that of some experiments and other references , and it is satisfactory . the subroutines can be applied to the stress analysis of turbine disks in aeroengines
计算结果表明接口子程序具有在不同应变率条件下、应变率跳级拉伸条件下以及循环载荷条件下的模拟能力，程序正确、可靠，适于涡轮盘等发动机热端部件的应力分析。 |
| 9. | An experimental setting of thermoelectric module which can simulate alterable work conditions in the cold and hot sides at the same time was designed . and the experiment research on the effect of the heat removal in the cold and hot sides was done
设计并建立了一台可同时模拟冷、热端变工况工作的热电制冷实验装置,对冷、热端传热状况对制冷器性能的影响进行了实验研究。 |
| 10. | In order to improve the refrigerating efficiency of the micro - vortex - tube , we have proposed a cooling system of a micro - vortex - tube with humidifying at the hot end . the hot gas temperature is lower than the gas of environmental temperature through humidifying the hot gas in the hot end
为了提高微型涡流管的制冷效率，提出了涡流管热端加湿制冷系统，通过对热端气体加湿降温，获得低于环境温度的气体，同冷端气体一起制冷。 |
