Chinese translation for "仪控"
|
- control & instrument
- Example Sentences:
| 1. | Environmental protection control instrument and related equipment - introduction
环保仪控关联设备概述 | | 2. | Ramp metering signal
匝道仪控号志 | | 3. | Ramp metering system
匝道仪控系统 | | 4. | Ramp metering rate
匝道仪控率 | | 5. | 2048 supervision - control points , data treatment software and hardware , water level detecting meter , mosaic process plate , operation table , cctv , avr , ups
仪控： 2048个监控点数据处理软硬件水位检测计马赛克流程扳操作桌cctv avr ups 。 | | 6. | This article put forward the useful and easily - realizable and reliable control arithmetic and the way to realize the basic automatic control system of walking reheating furnace , on the basis of including the theory of process control , technology of dcs and plc , communication , fieldbus , and in term of the characteristic of the walking reheating furnace , also by using the electrical and instrument control equipment with the practical and reliable technology and advanced quota
本文在总结过程控制理论、 dcs和plc技术、网络通信技术、现场总线的基础上，采用技术实用、可靠、指标先进的电控仪控的装备水平，结合步进式加热炉运行的特点，设计了不同形式的既简单又实用的控制结构和算法，实现步进式加热炉的基础自动化控制。 | | 7. | We can realize the instrument control system and electric control system by using dcs and plc . the control system of reheating furnace is devided torol furnace area plc control system , roll plc control system and reheating furnace dcs control system . the controller of instrument and electric connect to the server of the operater station by the controlnet , by using dcs and plc , the technology of network and fieldbus technology to combine the process control system and process computer , intelligent instruments , drive system to realize the instrument and electric controll in one system
采用dcs系统plc实现仪控和电控系统，把步进式加热炉控制系统分为加热炉炉区plc控制系统、加热炉前后辊道plc控制系统、加热炉dcs控制系统等三个子系统，仪表、电气传动用的控制器通过同一controlnet控制网与操作站的服务器连接,通过采用网络技术和现场总线技术，将控制系统与过程机、现场智能仪表和传动设备连成一个整体，从而构成仪电一体控制系统。 | | 8. | Specification introduce software and hardware are design and characteristic about data communication of integrate digital i & c system in nuclear power plant , and we was analyze configuration of data communication software and hardware . the design of data communication software and hardware is available and high reliability , the data communication is sufficient reliability for nuclear power plant required
介绍了核电厂全数字化仪控系统数据通信软硬件设计的主要特点,并通过对数据通信软硬件结构的详细分析,指出了核电厂统数据通信软硬件设计高度的可靠性和可利用性等优点,满足了核电厂对数据通信高度可靠的要求。 | | 9. | Sludge disposal system availability range from c13 superscript bin discharging sludge dewatering mouth , until dry sludge provide material , burning , smoke and ash emissions purification of the entire output of mechanical equipment , process pipelines , electrical equipment , instrument control system and civil engineering , including the whole project within the scope of the design , construction , manufacture , installation , and trial run and test run after the normal operation of the after - sales service
污泥处置系统供货范围从c13标脱水污泥料仓出料口开始，直到干化污泥出料、焚烧、烟气净化排放和灰渣输出为止的整套机械设备、工艺管道、电气设备、仪控系统和土建工程，包括整个工程范围内的设计、施工、制造、安装调试、试运行及正常运行后的售后服务。 |
- Similar Words：
- "仪技术和二项式压缩算法" Chinese translation, "仪间" Chinese translation, "仪降跑道" Chinese translation, "仪介" Chinese translation, "仪科" Chinese translation, "仪控率" Chinese translation, "仪郎" Chinese translation, "仪礼" Chinese translation, "仪礼的" Chinese translation, "仪礼化" Chinese translation
|
|
|
